Recent content by fabepach00

Thanks for the great advice. I do have some router with the dual wic cards already. I should have mentioned I will be studying for the CCNP also. This means I will need a couple more routers, switches and most likely a wireless router. In the meantime I am going to ebay to try to find an access...

I am studying for my CCNA. I have the following equipment which I need to access from my 2 serial port PC. 2 2924 switch 3 2620 1 2610 1 2514 1 2524 I was hoping to make 1 of these an access server to avoid swapping out console cables. Let me know what options I have. Thanks.

CiscoGuy33, Thanks for the info. I just cleaned out my garage and found a 2620 and a 2524. Do you have the model # of the card I would need to turn my 2620 into an access server? I would hate to buy another router just for this reason alone. Thanks.

I am currently studying for my CCNA and now need an access server. I have a 2914 which I thought was useless but I think I can make this into an access server for all my routers and switches. My question is this: Do I just need to purchase the octopus cables with the rj45 ends, connect this to...

Thanks Brian, I think you are correct. I was racking my brain. I knew I could do router on a stick and add as many switches as I needed too. As long as VTP and STP were working properly. This could be the reason I could not find any sample configs out there. I'm not sure why I even asked the...

Burt, you are correct. I'm having difficulty trying to config the routers and switches to do this. I am using a .252 address for the serial interfaces which connect the 2 routers. All my subnets are 192.168.16.0 using a subnet mask of .240 or /28. How do I get the Vlans to talk accross the...

I have configured a router on a stick, but now I am trying to found out if this config is possible. switch1 to router1 to router2 to switch2. 2924 2621 2621 2924 I want to create vlans in switch1, then via vtp have them show up switch2. I also need to communicate from vlan1 i...