Recent content by ETBOY

HI MG2005, Are you using VG224 MGCP image? Where do you config fax relay for vg224 in callmanager? and if you have an MGCP gateway where do you config fax relay? Regards, MC

Hi, I'am NBX newbie. I have two sites with NBX 3.4.3 interconneted. It's possible for users from one site access to directory of internal users of the other site to dial that extension number? Regareds MC

Hi, I'm NBX newbie. I have two nbx in two sites interconnected by wlan. I have two E1 connection (from different providers) one in each site to connect to PSTN. In one of the sites If i receive one incoming call from pstn try to transfer to an extension in another site phone rings but i don't...

Hi, I have one MD110 BC12SP8 with ip networking configured to interconnect with Cisco CallManager 4.1.3 I have configuerd G.711 a-law. When i make a call from a phone of MD to a phone in CCM it works perfect with codec G.711 a-law being used. My problem is when a phone in ccm make a call to a...

Hi, I have CCM 4.1.3sr2. If i enable queue in attendant console and brodcast hunting, i'd like to know if can change MOH file for a file with " Please wait your call is on hold"? Another thing is shouldn't calls in broadcast queue automaticaly goes to a free line? Regards MC

Hi, You could use Telebutler from Voxtron,they could also use as an IVR. Regards,

Hi, First question is: Are ELU32 and ip phones in same network address? Because if not there is a router in midle and multicast traffic that is necessary to automatic gk discovery work are not forwarded by router if not configured. Second: GKID in ECC or in IP phone config file should be...

Hi , check Gateway ip address. Regards

Hi, I have installed CCM 4.1.2 and sometimes some ip phones can't make any kind of calls but they can receive calls. I have to remove line and add line again. Anyone have experienced this problem? Regards MC

Hi, For call Manager express with 7960 and 7912 ip phones i want to display corporate logo. In 7912 i have to copy to flash picture.logo and gkdefault.cfg , correct ? And then do i need to config any IOS command? Regarding 7960 i have to copy picture.xml to flash? And then in interface GUI...

Hi, I want to implement QoS for voip in wan links beetween sites.I have 3 sites connected to my Headquarters each link 10M. In my Headquarters i have the following config in router: class-map match-all platinum match ip dscp ef class-map match-all best-effort match ip dscp default ...

Hi Trident, What should i configure in vendor spec in DHCP? I have configured one switch port with my voice vlan, and i haven't configure that vlan id in phone, and it's working what are the advantages configuring vlan id in phone? Regards.

Hi, Thanks again! My problem is not the ringing, because in line settings i have the options of flash only or disable. Major problem is caller id appearing in both phones, and it seems that there isn't a solution for this because i have two separate partions i can't monitor the line. Regards, MC

Hi, Thanks a lot for your detailed explanation, but i still have one doubt, when your two ip phones 2028 are ringing do you see on both phones display caller id? My problem is that i don't want that phone B knows who is calling to phone A. what phone firmware do you have? Regards MC

Hi jerake75, I don't understand you very well. Are you saying that when someone calls to a Directory number that have privacy enabled, the information of this call shouldn't appear in the shared line, correct? you talked in " the line you set the privacy setting to ON " i only see privacy...