Recent content by esreverse

Ok, Great. BTW. i wanna have the Dutch Locale with US keyboard as standard for all Users. I already tried to use setlocale, a small tool to use within the logonscript to set the locale at login. Because this problem is a bug, this tool will not work properly. I am running an Engl. Version of...

Gia, It is in Application mode. I don't think it has something to do with it. (En ook niet aan de Engelse versie van w2k ;-) )

Hi there, When i connect to a w2k TS with Microsoft RDP the default Input Locale is always UK. I cannot change the default input locale. When i configure the default Locale to use a different default Locale then the Locale, visseble in the taskbar, is switching back to UK when logging off. The...

If these Domains are connected with a LAN or VPN you could make a trust. If you make a trust you can select users from that other domain to give them rights in your Domain or vica versa. Then you could log in in your own domain and go to drives on the other. Do you have a notbook?

Any Antivirus like eSafe running?

How big is this new drive?

Is this on a network or a standalone Computer?

Damn, i should have read the article wich Jay posted before reply to it. Oke its not a big deal for anyone who don't wanna spending time, reading Microsoft Articles. ;-)

This is not what i am looking for BitFuzzy. The problem thing is how to setup IP to connect from LAN1 to LAN3. In my testing i can only ping from lan 1 to 2. I think the problem is IPsec to pass trough packets from Lan3

Hi, I want to setup IPsec-VPN, subnet to subnet; LAN1-Linuxbox-INTERNET-Linuxbox-LAN2-InternalGateway-LAN3 LAN1 will be 10.100.x.x mask 255.255.0.0 LAN2 will be 10.150.x.x mask 255.255.0.0 LAN3 will be 10.200.x.x mask 255.255.0.0 I need to have Clients on LAN1 can Reach IP's in LAN3. Is this...

AnyOne nows how to prevent Take Ownership? To secure a HD when moving to another system? Greetz

Proberly it's a security problem. Try to use the properties at the folders and look for Permissions . Add permissions for your account.

Therefore always make a rescue point before changing anything. Point back when finisch testing. Maybey you want to have a dual boot XP, so you could use a seperate XP installation to test software and hardware, leaving your working version alone. Good Luck;-)

You could try to use msconfig to look for changes with or without the extra drives attached. XP does not remove New Hardware when you remove devices from your computer. Try to Uninstall the device before you Remove it from the computer. So hook up the Drives again and then uninstall from the...

Check youre Bios again. The best is if you now the configuration of your attached devices on both IDE controllers (Mainboard). Wich one is attached to what IDE controller. Presume you have de IDE disk as a master attached to the Primairy IDE controller. Then you only need to enable IDE0 in the...