Recent content by EricOtt

The exact same thing happened to me. Conclusion from MCK was that the flash memory on the board was defective. Had to replace the unit. The image was there but couldn't load into the flash memory, saw an error and kept rebooting. Don't know if it helps but i thought i could share!!

I'm using the NEC BlueFire IX2010 routers at both the main and remote site. I'm also on dedicated DSL circuits 1.5 MBs

Sorry for being late, I'm currently running service pack 2 (Did the upgrade from the cd's).

BTW I'm using ADSL high speed at 1.5 Mb/s with 2 NEC bluefire router IX2010. There is no computers on the ADSL. It is used only for VoIP. Thought you should know!

Hey Chris, 1)I've tried calling internally from a IP Phone at my remote location to another IP phone at the same location, works fine. I've tried from IP phone @ remote to DTH phone @ main location, works great too. Quality is good. 2)If i'm at the remote location, on a IP phone, and having a...

Hey guys, i'm using a IAD card to do VOIP (Megaco) on Elite 192 V9.5. Everything works like a charm except for 1 thing. When i'm at the remote location and having a conversation with an outside caller, sounds like the voice/phone works like it's half-duplex. I've tried all sorts of adjustments...

What type of voicemail is it? If you look inside the cabinet, it should tell you on the card either FMS or VMS or VMP and if you look on the hard drive/flash card it will tell you the version of it. Usually starts with Q then 5 digits. There has been some issues with voicemail card locking up...

Changing the time and date on the Nitsuko 124i telephone system: 1) All time changes must be made from extension 301. 2) With the phone hung up press CALL 1 3) Dial 828 4) Dial the Password (Normally 0000). 5) Dial two digits for the year (e.g., 97) 6) Dial two digits for the month (01 -...

I've installed a number of those CT-U adapters and had very few trouble with them. One of them was giving me the same trouble as what you are describing and figured out that the software i was trying to interface it with was not compatible and not supported by NEC therefore i changed the...

After fiddling around with all the dipswitches and connecting deconnecting and reconnecting left right and center i got this thing going. I wrote it all down for the next time!!! I am using T1 interface. Thanks for the reply.

On your system, when you press 9, it will grab a free line on your system starting by the last one in the line group.i.e if you have 5 lines it will grab line 5 then 4 then 3 etc... On that specific phone that shows an error when you press 9, it seems like you don't have a line appearance on...

I have two IPK systems that i need to hook up together via K-CCIS. The 2 systems are side by side and i have all the hardware necessary but not quite sure what gets connected to where or on what. I do have the programming manual for it but without the hardware correctly connected it obviously...

Electra Elite 192 Line name is the title of his post!

To edit lines, it's mostly in system mode 3.The data no. will depend on what you want to do. To change the line name it is 00. Trunk-to Trunk group it's 03 etc...

2)Ring back tone on elite192 wont work if the version software is lower than 7.01 (To check it press feature + 3 on any phone). Unless they've changed it or there is another way,i've tried and it doesn't work.(Unless you upgrade)