Recent content by epoxync

http://www.epoxysbox.org/tmp/dns/named.conf http://www.epoxysbox.org/tmp/dns/zones.conf that's the just of it.. I have been on this for a week now. I have another server i set up at home and for a friends, that seems to work great. I can't seem to get hosts from the outside of this network...

http://www.epoxysbox.org/run until then.. here is a trimmed config.

hehe i tried to up a few posts.. it's not my config i just know enough cisco to read a little of it and get my in trouble.. i'm not the cisco guy here, i just set up the services on the boxes :) the cisco guy is fresh out of ccna and doesn't even grasp a lot of basic stuff :( ... but my boss...

the above is the config retaining to that... http://72.243.212.6/run.txt & http://www.epoxysbox.org/run is the whole config (both the same thing.. incase one goes down.)

oh, one more thing.. i can telnet to tcp port 53.. and it looks like it is open by other means. I can dig www.mydomain.com and it queries names.mydomain.com fine and replies with the correct external IP... but the external host i am going the dig at doesnt get the reply

oh and the IP seems to be natted fine.. i go to www.ipchicken.com or something and my ip is 72.243.212.6, which is what it is supposed to be. (the router is .1) also, i dont think i have any ACL's applied to that interface, so wouldn't there be an explicit allow all for it? i still haven't...

ip nat inside source list 101 interface FastEthernet0/0.10 overload ................ ip nat inside source static 172.16.0.6 72.243.212.6 .............. ! ! access-list 2 permit 72.243.212.200 access-list 101 deny ip 97.66.10.96 0.0.0.15 any access-list 101 permit ip any any access-list 102...

At work, we have a cisco 7200 vxr router with some 1-to-1 nats on it (external ip <----> internal IP) 72.243.x.x external 172.16.0.x internal We are delegated a whole C class and only use about 8 of them. I have a dns server on host 172.16.0.6 (72.243.212.6) for names.ehome411.net ...