Recent content by enzo288

I have a client running both EqualLogic and NetApp with about 1PB fo data stored on each platform. He is wondering if there is a SRM capable of managing both platforms as if they were one. Does such a thing exist?

The safest thing to do during an IOS upgrade is to push the current up to a TFTP server and then delete the .bin file. After issuing the "squeeze" command you then can copy down the new image file from the TFTP server, configure the switch to boot from the new image and then reload.

Thanks Nate!!

I am installing CW LMS 2.6 for a client which needs to have HP Openview ITO integrated with it. I can't find any documentation on how to accomplish this. Can anyone help?? TIA

I am installing CW LMS 2.6 for a client which needs to have HP Openview ITO integrated with it. I can't find any documentation on how to accomplish this. Can anyone help?? TIA

This looks good. Thanks for the quick response Tom.

My client has two Cisco 7204 routers with two separate ISP connections via DS-3. I am configuring a third DS-3 connection for them however, only thier lab subnet should use this particular Internet connection. The issue I have is that means that there will need to be a third default route...

Yes, this is to be a full DS-3 circuit terminating into a Cisco 7204 router. I just found out from AT&T that the protocol is UNI, and the encapsulation setting is AAL5MUX IP.

I would like to see a sample DS3 config as I will using this card in a Cisco 3845 router. TIA

I would like to see a configuration example for DS3 as I will be using this type of card on a Cisco 3845 router. TIA

I've never installed this before and I have just now realized that not only willit not run on Server 2K3, but it does not work w/ LMS 2.5 either. 3.2 is the latest version?? What's the deal. Anyway, I obviously need to install it on a seperate server but myquestion is that with it on a...

To get this to work, I needed to take off the existing default route on the 3560. I then needed to change the default gateway for each subnet to the IP address of the inside interface of each companies firewall. Normally the DG would be 10.0.0.1 and 192.168.0.1 which are the IPs of the VLAN...

Would this then work with two default routes on the L3 switch and client machines obviously using their respective VLAN int as their DG. Also, this client does not have fiber so could I configure EtherChannel on a trunked port, I have never needed to do this but I am thinking that you can't...

Anybody??????????? CCNA, CCDA, CCNP, CCDP, almost CCIE

VLAN1 should not be used. Create a VLAN for the users, one for the servers, and one for switch management. Also, depending on the size of your network you might need 1000 Mbps connection to the servers. If you have a large amount of users hitting these servers over a 100 Mbps connection, it...