Recent content by ELECTRICWARRIOR

I have a 6360 that prints cyan when not called upon to do so, the problem does not occur in the self test, a grey chart sent to the printer will come out blue the same chart sent to another printer comes out grey it's not a driver issue it's a PC issue as 3 different PC's exhibit this issue and...

had to replace the formatter.

turned out to be the fuser had a crack in it

old drives scans ok

no removable ram, does have a hard disk drive which it loads it's firmware from. not under warranty.

prior to this it was stuck permanently stating " checking printer" would never advance further than this, cannot print anything but engine tests, can get into pre-boot menu no problem, tried another formatter but was unable to use it do to the encrypted disk drive was locked to that formatter...

GETTING A 49.2f.d8 ERROR ON AN hp cp5525 HAVE RELOADED THE FIRMWARE and re-seated the formatter -- the unit is not currently networked or connected in anyway to a computer, it's not a bad job. have also cold reset to no avail any ideas?

i have a Konica magic color printer 7450 it has a repeating image defect every 130mm across all colors i'm leaning towards the fuser, however inspecting the fuser does nor revel and defect, the service manual does not include any info with regards to measuring repetitive defects.

I have a 6250 that jams on tray 2 fine on tray 3 and manual tray 1 when it jams it prints out the second page and then calls out the jam, the jam is exact for every print so that rules out a roller slip as it's more of a exact fail, i measured the printout on the second page as it's skewed in...

i'm receiving a remove tape from yellow cartridge Xerox 6180 -- the error will advance to the next cartridge and so on until back to the yellow cartridge so it doesn't appear to be a cartridge issue -- i opened up the unit and found that the grounding plate had broken loose i re-attached to no...

LEAKY TONER CARTRIDGE, QUITE COMMON ON THOSE

seems to be somewhat common, 8400,8500, 8860 series, any have any ideas other than the norm. ram reseat ram shuffle ram replace all which have been tried, hate to have to put $600.00 bucks into it for a new system board.

I'm looking for the gear that operates the shutter assemblies for the Xerox 7400 it's a small gear on the left side of the cover that opens and closes the shutters when the top cover is opened/closed, i currently have two units that need this gear, i could not locate via the IPB.

i replaced the batteries in two APC rack 2200's as the battery LED was showing RED --- i let both units charge up over the weekend -- and then rest then via the test button by still cannot get the led to turn off, powering off the units is not a current option!

no