I have deleted the access list line as suggested.
and if i do a show log (show xlate does not seem to work on my cisco 2801) and filter the log by the ip address i am using to test, i have:
RTE1EBR200-01#sho log | include 192.168.100.17
006500: *Sep 19 17:04:25.414: %IPNAT-6-NAT_CREATED...
Thanks Agentk and burtsbees for your prompt answer.
Agentk, i will remove and try. I cant recall why that rule is there.
burtsbees, the file attached is a sh run, after i did a wr mem.
thanks,
Hi there, i have a cisco 2801 advanced ip services that i managed to configure using cisco documentation. i am no cisco expert and i have 2 small problems to finish my configuration.
1- my network 192.168.100.0 cannot browse internet
2- incoming phone calls from pstn make cisco phones ring but...
Thanks for all your help, I would like to post some other details in hope it will help others.
After dealing with this Layer 3 switch all weekend:
1- Create the VLANs and assign the ethernet port that will be needed per VLAN.
2- When you want to route between VLANs you must assign an ip address...
Hi,
I have a 3COM 4500 (26 port) swith and I already created vlans. I need assistance with the following.
Note:Vlan 1 has two adsl modems connecting me to internet
first adsl address 201.224.36.x
second adsl address 201.224.35.x
a- How to communicate vlan 2 with vlan 3?
b- How to communicate...
Hi, I still learning perl so I excuse if this question is lame.
I have several files in my local disk, generated by another application (made by a 3rd party) with the following data:
*******(extract of the file)*************
.\" Definition of the Page Header for the first message
.de PH
.tl...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.