Recent content by dutronc66

Hi, I put the "ppp authentication Chap Callin" command on the BRI and now it's goin' on. Thank you very much

Here are the configs. I have a trace made by the ISDN provider (from the Switch to the central route) if you want to version 12.2 service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname central ! enable password 7 104D ! username username1 password...

I'll try to explain better (i'm spanish) If you write a sh int command: remote#sh int BRI0 is up, line protocol is up (spoofing) Hardware is BRI with S/T interface and POTS MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, You see the BW is 64 Kbit but the Bw that appears in the Dialer 1 is 56...

I have only used one BRI interface for five dialers (the interface BRI1/0 is connected to the five remore routers) Yes, i reloaded the router after changin' its conf. I did the debugs on the remote one (sorry i have no the other one) ISDN BR0 Q931: TX -> SETUP pd = 8 callref = 0x03 Bearer...

Hi, i put the new conf on to the remote router but it didn't go right. There are five remote routers (i only put 2 to simplify)and i reconfigured the router the one that is bound to dialer five (in the central route). Maybe, this would be the problem. Should i add the "dialer load-threshold...

In which conf I have to put these two commands) The central? remotes? or boths? Thanks

Thank you very much. i'm testing in 2 hours. I don't know if split-horizon should be on or off. What's your advice?

thanks. The central config is the next: version 12.2 service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname xxxxx ! enable password 7 104D ! username aaaaaa password wwww username bbbbbb password wwww ip subnet-zero ! ! no ip domain-lookup ! isdn...

I´m implementing ISDN dialup connection from several 803 cisco remote routers to a 2600 central Route on the same Bri interface. I have no problem when the central one calls but the remote routers can´t. In the central route q931 debug i have the next lines: ISDN BR1/0: RX <- SETUP pd = 8...

Hi, This is the first time i work with Cisco. I have to connect a central route (Cisco 2610) with 6 Cisco 803 on a unique BRI interface (ISDN). The 803 routers should connect with the 2610 and the 2610 should connect with them. Can i do this with a snapshot configuration? Which is the best...