Recent content by dtabera

Hi dozier, Did you check connectivity? Is NAT working fine? Did you issued 'deb ip nat det' and 'show ip nat trans'?

Then, hope this helps: Table 6 Dynamic RAM Upgrade Kits for Cisco 801-806, 811-813, and 826-828, 831, 836, and 837 Routers Description Cisco Part Number 4-MB DRAM module MEM800-4D= 8-MB DRAM module MEM800-8D= 16-MB DRAM module MEM820-16D= 32-MB DRAM module MEM820-32D=...

What are you looking for exactly? the part number? or the place to plug the memory in the board?

Me too :-) thanks JOAMON. I will try to convince my boss to make some changes in the network...

Hi TLDuk: From Cisco web page, 830 series routers have 64MB DRAM memory by default: http://www.cisco.com/en/US/partner/products/hw/routers/ps380/products_data_sheet09186a008010e5c5.html And I think it is not upgradeable. can you paste a 'show ver' and the first lines of 'show mem free' to...

Hi all: I am trying to configure NTP secure client associations for all the routers in my network. Our NTP server does not admit authentication, so I thought that NTP access group could be a good choice. But, do I need to use NTP access group for clients? The config is only: ntp server 1.1.1.1...

Have you done some debugging to see what´s going wrong? show ip access-lists deb ip pack <acl no.> detailed Diego.

Hi: Have you used 'gt' instead of 'ge'?: access-list 100 permit tcp any any eq 80 access-list 101 permit tcp any any eq 80 access-list 101 permit tcp any any gt 1024 access-list 101 permit udp any any gt 1024 or access-list 101 permit tcp any any eq stablished (something like that)

Thanks mate, I will try it. D.

Thanks Brat and NetManRick. Actually, I have two cards: a 8MB card inserted in slot 1 with sw 14.00, and a brand-new 16MB to store software version 15.00. Is it possible to have this second card in slot 2 with the new sw version, and boot the router with the new version using: bcc> boot...

Yes, they are stacked with SPEX-HS. D.

Hi: I want to upgrade a 3 slots - ASN router to 15.00. I have a spare 16 MB flash card to install in the ASN. I am not sure wether I need 3 16MB flash card or only one. I have read in "Installing and Maintaining ASN Routers and BNX Platforms" that I must use at least 3 flash cards, one for...

Thanks Brat2: when you say straight cable and one-to-one connections, you mean pin 1 to ping 1, pin 2 to pin 2, and so on ¿right?: D.

Hi: Does anybody knows if the ASN serial console cable (9 pin to 25 pin connectors) has a special pinout? I have been reading cable guide but I do not see it clearly. Regards, Diego.

Hi everyone: I have a PIX 506 that does not load IOS. I know that if I take out a certain jumper in the motherboard, switch on and then off the device, and then I place the jumper back on its position, the PIX loads IOS and starts working. But I am not sure which jumper is the one I have to...