Recent content by drpigskin

Where in the BIOS can I change that setting. Searching the BIOS I didnt find that option.

I am trying to reinstall Xp Pro. During the process the computer will get thru the format process and start to copy files on to the drive. At different points in the process it will state the following message, "Cannot copy file from CD". I checked the cd and it is fine and tried a...

The motherboard arrive a day early and it took me about 20 minutes to swap it out with the old one. I hooked all of the rear cables back up and hit the power button, didnt have a good view of the monitor so we I didnt hear a beep, I assumed that it was doing the same thing. I bented around and...

Took all of your advice and it tends to point to the motherboard. So I have ordered a new one off of Newegg.com. It is suppose to arrive tomorrow so we will see if this fixes the problem. I will keep you all informed, thanks.

As far as I can tell there isnt a short in the board, it work prior to upgrading the CPU and I didnt not remove or replaced the board. I dont even get the slightest bit of a video signal. The monitor keeps telling me to check the connections. Right now I am going to try a different computer...

Yes the PS fan is running and so it the fan on top of the heatsink, the lights on the Optical drives also work. It seems to totally power up other than it wont post. As for the secopndary power connecter this board doesnt have one

Yes I did reset the bios jumper, I tried it both ways just in case I had it wrong

PS I posted it on the board because I also upgraded the hard drive to a Maxtor 40Gb. I am sure that it can handle it since I was just replacing a 30gb hard drive

After I upgraded my daughter's computer to a Duron 1800 on a QDI Kudoz 7 v2 board all I get is the computer to power on and no post, not even a single beep. I tried putting the AMD 1100 back in and the same problem exists. What could be causes this, I tried reseating both the CPU and the...

Thanks for all the suggestions on how to handle this issue, not matter that none of them helped solve the problem. In the end I had to FDisk and format the drive once again. Then I reinstalled Windows XP Professional. Thanks again for all that tried to advise me.

Thanks I will give that a try, I am assuming that if I uninstall everything, then install in the order you suggest it will be the same.

I have tried the compatibility mode with the short cut, it doesnt work because its not a local file. Groupwise setup is located on the Mail Server. I also have uninstalled both the Windows Messenger and used the Groupwise Cleaning agent to start from scratch with this install, doing both...

thanks for the help but the install isnt local its off of the mail server

I am trying to install Groupwise 5.5 on a clean Windows XP Pro desktop. The windows messaging system has been already installed. Everytime I try to access the Client32 setup file, I get a pointer and a hour glass for about a second and then it just goes away, nothing happens. I have try both...

I am trying to install Groupwise 5.5 on a clean Windows XP Pro desktop. The windows messaging system has been already installed. Everytime I try to access the Client32 setup file, I get a pointer and a hour glass for about a second and then it just goes away, nothing happens. I have try both...