Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by droudpeyma

  1. droudpeyma

    CDR users not showing in reports

    Hello all, I'm having some issues where users that are created in Call Manager are not showing up in the CDR reports for Bills/department. We had a wave of new hires and I created accounts and associated devices to them. Most of the new users show up but there are a few that still do not. Any...
  2. droudpeyma

    6513 CSM

    Hello All, We have a 6513 Chassis with a CSM configured with mulitiple serverfarms. When HTTP requests come into lets say our web farm with a virtual IP of 10.10.10.10 and the servers have real addresses in the range of 10.0.0.1-10 the web log shows only the virtual IP as the source inbound. Is...
  3. droudpeyma

    Cisco VPN Question

    I am having a similar issue with our ASA. However, once the VPN client has established a connection, I am able to TS into any of our servers in the office.(Without changing the properties of the NIC) The problem I am having is accessing the internet and being connected to the VPN client at the...
  4. droudpeyma

    Outlook 2003 recipient periodicaly not getting email

    Hello All, I have a few users who say that they are periodically not getting emails from users inside and outside. Also, while looking at their emails in outlook, sometimes they dissappear from sent folder or there is no record of a message that was just sent. There are also cases were a user...
  5. droudpeyma

    Cisco VPN client

    Matt, Thanks for the response. It seems that you are right. For some reason, when I tried to connect to our VPN witht the Cisco client it wasn't working before. Now it is working just fine. Thanks again :), Dave
  6. droudpeyma

    Cisco VPN client

    Hello again, I have configured an ASA5520 to allow VPN clients to access our corporate networks. Everyhting works fine but my question is in regards to allowing any client to connect. Is it possible to set an IP pool to allow any external IP address to access our internal network via the VPN...
  7. droudpeyma

    Site to site VPN reconnect

    Hello all, I have an ASA5510 and a PIX 525 configured for L2L VPN. at one point in time someone changed the pre-shared-key on our ASA and now I have corrected the error but cannot restablish the tunnel. Is there a way to reconnect the VPN tunnel without rebooting either firewall? Thanks in advance,
See more

Part and Inventory Search

Back
Top