Recent content by DrJ100

I think I figured it out. I didn't realize you had to hold down the send button for 5 seconds, it worked after that. Thanks.

I am having a similiar problem, I have 2 T7406 handsets on one base. Initially, I was able to turn on the phones and make calls, but the customer was complaining of static which I did not hear so I tried switching the dip switches to switch to the other range, the phones said scanning...

Can anyone recommend a good unit to use on the test jacks for 100R INA cards and where I can get one? Thanks guys

Merlinman, How do you convert the hardware and firmware versions to a 517_15 type of description? Thanks in advance, J

Thanks guys! I do have it set up as PRI on the DS1 and DCD. Any idea why I am able to do the test on the DCD but it fails on the Legend DS1? Will switching the ds1 over to T1 to do the test tell me if the PRI functionality of the card works? I appreciate you guys getting back to me so quickly...

Does anyone know if you should be able to perform a loopback test on a legend DS1 card using a line cord as described above? I can perform the test on a 100dcd and it comes back successful but on a legend it gives me a test failed message. Thanks.

Hi Ghostin, I took a look at your cheat sheet but I am wondering if you could tell me what the difference is between a T-1 crossover and a standard Cat 5 crossover cable. Thank you Jesse

Yes, I did assign my lines in reverse order to group 80 and I did take a look at the cheet sheet everything looks good there, the tech for the simulator set it for 5ess so that's what I set the Magix system for. He was a little confused about the last paragraph in the cheet sheet where it...

Franke, Thanks for the post that makes since. I am still having trouble getting it to work, when I place a call from the simulator nothing happens, it seems like I'm missing something else. Any other ideas?

Does anyone know where to get the 6.0.4 patch? Thanks in advance, Jesse

I am setting up a system with an Ameritec Alegro T1/PRI simulator so I can test DS1, DCD cards etc. I have it set up for PRI routing by dial plan and I wanted to make sure I am setting up the pattern programming right, if my dial plan starts at 100 can I program the lines for the b-channels to...

Thanks for the reply, actually I found out that it needs to be programmed to start with the right extension range. I just assumed that would be automatic. Thanks, Jesse

This site looks very helpful, I was hoping someone knew what would cause the 2nd DSS to not work on an MLX-20L which is programmed as an operator extension. The first DSS works fine, their is also a second operator extension set up the same way and the 2nd DSS is not working either, they both...