Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by dortega4226
-
Creating LiSP to isolate drawing layers w/ & w/out Xrefs
CarlAK and anyother looking into learning how to write or edit AutoCAD LiSP the website given above in the wrong extension. Here's the correct website: www.afralisp.net David J. Ortega 3D BIM Coordinator Brady Company/Los Angeles, Inc. AutoCAD 2011 | AutoCAD Architecture 2011 | Revit...- dortega4226
- Post #6
- Forum: Autodesk: AutoCAD
-
Creating LiSP to isolate drawing layers w/ & w/out Xrefs
These all sound like great tips. I'll be sure to try them first thin Monday morning. I have a question about using "*BH-*" over "*|BH-*", would I still be able to turn off the layers that are being Xref'd? If so, then I don't believe it'll have any bearing on any other layers. Thanks for your...- dortega4226
- Post #4
- Forum: Autodesk: AutoCAD
-
Printing a lot of blank paper
What type of printer are you using; KIP, OCE, HP? In most printer menus, there is a box that is required to be checked when you only want that which is plotted to be cut from the roll and not the entire sheet specified. On my HP DesignJet T610, under the Features Tab in the Printer Preferences...- dortega4226
- Post #2
- Forum: Autodesk: AutoCAD
-
Creating LiSP to isolate drawing layers w/ & w/out Xrefs
I've done some searching and tried to modify several versions of LiSP I've found, but non of them do exactly what I need... well, entirely what I need, just a variation of. I'm not very familiar with LiSP, hence the troubles, and I've spent too many hours trying to figure this out all alone...- dortega4226
- Thread
- Replies: 5
- Forum: Autodesk: AutoCAD
