Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Docsharing

  1. Docsharing

    IP Telephony: Phone 7971G-GE failed reseting to factory defaults... an

    I was trying to reset device to factory configuration defaults, on boot i press # and then 123456789*0#. A Cisco logo screen appears with text "upgrading", and no starts. I have tryied to unplug and plug power again but nothing happens: cisco screen appears again and "upgrading" message. Has...
  2. Docsharing

    Extension of html e-mail changes to ".h"

    One user of the site is suscribed to a massive bulletin that sends every week a bulletin in html format. But the problem is that this e-mail is received in the Outlook of the user like attached file with .h extension. If you saves the file to hard disk and changes the extension to htm, the file...
  3. Docsharing

    URL filtering with 1800 router

    RADIUS or TACACS would work? do you know a document or link about url filtering per-user ising RADIUS or TACACS? Thanks a lot
  4. Docsharing

    URL filtering with 1800 router

    Hello, I want to create internet access policies per-user based: many users could navigate to all urls, and many users only could navigate to a group of urls. (Based in source IP, or souce MAC, or using username/pass to each user) How i could goal this using a 1800 router? using AAA local...
  5. Docsharing

    Linksys VLAN's again

    Well... i have read if you set per-port VLANs you don't need a router to that... If you set one port (internet port) sharing between both VLANs, it must work fine... But don't works...
  6. Docsharing

    Linksys VLAN's again

    I have read a lot of messages about Linksys VLANs and i think if really is true if anybody could make work it properly... Well, the typical situation: i have a Linksys Switch SRW2024, i want to create 2 phisical networks, separate, but sharing internet connections. Schema: Port 1: R1 ISP...
  7. Docsharing

    Uninstall SP2 after instalation failure

    Hi all, i have a problem with Office 2003. I was trying to apply the SP2 using object policy when the instation crashed. Now when i try to install de SP2 again, installation aborts with error. System Restore not runs (it was shutdown) and y need to erase the aborted installation, and then...
  8. Docsharing

    Question about PA-FE-TX and 7200

    Does anyone knows if PA-FE-TX supports 802.1q protocol, or only supports ISL? Datasheet only refers ISL support. Thanks, regards
  9. Docsharing

    Cisco 1801 dial backup (near the suicide)

    Hi, I have done a right reverse telnet with the modem. When i send AT, modem request OK. But the problem is here yet: when F0 goes down, dialer0 wakes up, but no dialing, no modem noise, no leds blink.... nothing. I was trying using diferent innitialization commands for USR modem, but nothing...
  10. Docsharing

    Cisco 1801 dial backup (near the suicide)

    To HELPDESKDAN: "debug dialer" the most of times not shows anything. I don´t know how i could reverse telnet to the modem Thanks a lot To KISKOKID: 1- Yes, sure 2- I will try using "ATDT \T" and CONNECT \c 3- I'm configuring only a test. User and password are not important to me now, because...
  11. Docsharing

    Cisco 1801 dial backup (near the suicide)

    Hi all, I'm trying to configure a Cisco 1800 router dial backup to US Robotics 5630D analog modem by AUX port. I have read documents about it but not runs, but not runs. I configure interfaces like this: INterface F0-> 192.168.1.212/24 GW:192.168.1.252 Interface VLAN1 (switch)->10.10.10.1/24...
See more

Part and Inventory Search

Back
Top