Recent content by dlange23

Sorry forgot to mention that. I am connecting ethernet port to port.

I have a Nortel 5510 switch trying to connect to Cisco 3560 poe switch. I get an amber link and no green link light. Cisco side errors and says duplex mismatch. I have changed settings on both nortel and cisco a number of times with no avail.. I have searched this topic with very little...

Thanks GHTROUT.. I tried it and the channel which I used (channel 1) said idle. How do I get it to trace for a few minutes so I can see the collasion of the call coming out of the voip voice manager. Thanks

A call on a softphone would need to be transferred to a 2616 or be able to call to an internal number. The only way is through the gateway through the pri.

I have a option 61c with a vegastream gateway connected. I can call external local and LD, but internal calls will not go through. Internal calls will ring on the destination phone for a brief second and caller id is shown and then disappears. Any direction would be helpful, Thanks in Advance.

Here is my printout: ADAN DCH 7 CTYP MSDL DNUM 7 PORT 0 DES vega USR PRI DCHL 18 OTBF 32 PARM RS422 DTE DRAT 64KC CLOK EXT IFC NI2 ISDN_MCNT 300 CLID OPT0 CO_TYPE STD SIDE USR CNEG 1 RLS ID ** RCAP COLP T310 120 T200 3 T203 10 N200 3...

Thanks for the information. I have the dch setup just like you have it there. Does the route have to be correct in order for the d-channel to sync?

Hello, I am trying to connect my Option 61c (25.40) to a vegastream gateway via a T-1. I have set up the msdl and dch and loop, but I am having problems with the d-channel syncing. On my end (Nortel)the card is not an alarm, just the channels on the loop are in MSBY state. It might be a...

Thanks to all that has helped. I used ld 49 and it took. Thanks again. D

What ld do you make a phantom? Also if I build it in the IDC table will there be a delay when someone dials "0"? Thanks

I am moving a DID onto my switch, I will be directing it to an acd group (of which I have not setup). The problem is the last 4 digits of the phone number are 0630. This is a problem when setting up an acdn. The Option 61 does not like the "0". Any help would be appreciated. Thanks in...

I need to remove some patient phones out of the DND group. Right now the operator is having to manually program them out after she turns on DND. I would like to remove them completely. Thanks in advance for all your help. D

My Miran Card quit working, Is there anyway to enable and disable it? What else can I do to reset it. I use it for overflow on main switchboard. Any help is appreciated. Thanks D

THANKS FOR ALL THAT HAS HELPED... A BIG THANKS TO marcuspb. Going through config wizard and rebooting did the trick.. Thanks Darin

I called my Nortel dealer and they told me I to check if I was on SU02 or SU03. I am on SU01, they said I needed to be on 2 or 3 for the PEP to work. Hopefully that is the case. Is there anywhere I can locate SU03 and the PEP to install my self?? The Nortel dealer has a scheduling problem...