Recent content by djudjuman

If no interest, then the boards end up in the dustbin next week. [sad]

I have (NOT for sale, but for FREE, since selling is not allowed on the forum) the following MD 110 boards: 1 x ROF 1314507/1 R16C IPU 1 X ROF 1314507/1 R16B IPU 1 X ROA 1194275/2 R1A LPU display I.S.O. throwing them away, maybe someone can use them. If so contact me on henk@oegema.com

NIU2

Which analog interface? T-1 (and also E-1, I suppose ?? )

In stead of starting a new thread, I'll put my request here. I'm also looking for MD110 batteries. The specification of the battery is as follows: 12V 26AH Heigth (H) = 15CM Width (W) = 10CM Length (L) = 25CM Who can give me the name of a supplier?

How (where) to get firmware R6A ?

Is the method described in thread: http://www.tek-tips.com/viewthread.cfm?qid=344100 still valid?

Does a NIU2 board always have a licence on it? (when I order it from a supplier on the internet?

Can Direct Indailing (DID) be programmed on MD110 BC7 Version?

I'm looking for the following boards: LPU-6 ROF 1314608/1 QTY:4 BSU ROF 131854/9 QTY:4 SSU-2 ROF 1314293/1 QTY:2 Where can I buy these boards ? (refurbished or new) PSE reply at henk.at.oegema.com

I'm curious to know how Asterisk is performing together with MD110 ? Who else has experience?? See: thread806-1061992

Does it ring before? have u changed the telephone handset?if yes, checked another port on same elu28? swapped the elu28 board?????

I need information on this and will appreciate it greatly. In 3 mx-one system say A,B and C If A wants to communicate with B, Signalling is between the ELU32 or IPTU and media is via the IP network. The Question: If there is an IP trunk from A to B only and B to C only. A wants to communicate...

Thanks Dave for the Help. Where can i get the interpretation of the letters B and C ?.In Alex i can see NC though as a double character condition code but not C separately and B. Cheers

A call logging was programmed on Ericsson BC10 and the format used was a user defined form. It was noticed that it generated some condition code NC,and B which are not listed in Alex. It still generated condition codes that can be interpreted in alex. On trying to view the form programmed...