Recent content by DiStefano

Thanks Billz66, Did they manage to make something out of it though ? The documentation is very limited and missing vital information in regards to how you call these routines. ///Stefanovitch

Anyone done anything with the SDK that comes with former UCA now MiCollab Client ? It can be integrated with .NET and COM platforms. It comes with the client install using TelephonyProxy.dll ///Stefanovitch

Should do LoopyLou. If you remove the extra multicall, the dss/blf key works a treat. But then transfer/conf does not work... I think I've answered it myself, it works the same way for mitel deskphone, if you have a second multicall key of your prime number, then your extension will never show...

With a DSS/BLF key you can monitor an extension, does that work for a UCA sip softphone ? It wouldn't I suspect since you need to configure an additional multicall key on the softphone for transfer/conf. IE when the softphone is busy the second line is actually idle so a dss/blf won't show busy...

mitelman you are quite right, Thanks a lot. ///Stefanovitch

Where do you set on a ip phone, not to send A-number to public isdn ? I have some ip phones that I want to be able to send their A-number and some that I want to not. What is the easiest way to do this on the 3300 (5.2) ? ///Stefanovitch

This might be a easy question. I want to print a brochure/leaflet in 1/3 A4 (210mm*99mm) and double sided. Double sided I can handle. But How do I do this A4 format ? The format is an A4 folded twice. Like DL envelope size, but this is not an envelope, it's going to be a brochure printed in 3...

What is the difference between RJ48 and RJ45? Are the pinouts the same, just different kind of plug or ? ///Stefanovitch

The STOP-N won't help here. I'm using a Netra CP2300 CompactPCI board, I'm trying to boot the system and it's coming back asking for Firmware password, which I don't know... The system is trying to boot from disc. This is what you see on screen when starting system with STOP-N pressed...

Anybody know if the MD110 will support SIP in the near future ? What about VOIP cryptation ? ///Stefanovitch

I'm using hyperterminal to run a Sun cpci system. I'm trying to boot Sparc/Solaris and it comes back saying "Firmware password:" I don't know the password, how can I bypass this ? I've found in manuals that you can press Stop+N during bootup, to reset to factory settings, does this...

Just remember that VCU board is not supported in BC11. You can swap the VCUs to Ericsson and get SPU2s, I believe. You can upgrade site by site to BC11. BC9 to BC11 interoperability is fine. We did the same for a huge customer, going from BC9 to BC11.

I can print one page at a time by pressing "Go" key.

If you boot the printer this comes up on display, "68.0 permanent storage error, check settings" Nothing has been inserted into the printer. No memory etc. The testbutton works ok, it prints off a page with lines vertical on portrait. More suggestions ?

Will try on MOnday, Thanks.