Recent content by dips00

For anyone with a similar issue, here are the commands to "activate" the port: conf t Configure "card-type T1 2" Then "controller T1 2/0". Thanks,

Just verified, the vwic is supported by the 2811.

Hi, I installed a new WIC (vers.2) in 2811 but I do not see a serial port available to configure. I restarted, still no luck. Sho Diag does see the wic installed. I tried moving it a another slot but the same thing. Do the wic's need to be "activated" or something? yourname#sho diag...

Burtsbees, correct, the vlan and dhcp server are on the same switch.

10.11.44.3 is the DHCP connected directly to the switch.

Hi, I am running into an issue where a laptop connected to a switch that has ip-helper configured is not able to get an IP from the dhcp server. The switch can ping the DHCP server and vice versa. I also tried to setup a separate DHCP server to rule out the dhcp server being the cause but no...

Hi, I am not able to create a vlan on this model router. I get an % Invlaid input error. Here is the version of the ios. Thanks in advance. ROM: System Bootstrap, Version 12.2(4r)B2, RELEASE SOFTWARE (fc2) BOOTLDR: 7200 Software (C7200-KBOOT-M), Version 12.1(14)E6, EARLY DEPLOYMENT REL...

.1 and .2 are fa0/23/24. I am wondering if the gateway can be configured incorrectly.

correct, .3 is on fa0/25 and .4 is on fa0/26. VLAN Name Status Ports ---- -------------------------------- --------- ---------------------------- 1 default active Fa0/3, Fa0/4, Fa0/5, Fa0/6...

Layer2. No access lists. The config is below. version 12.2 ! ip subnet-zero ip routing no file verify auto spanning-tree mode pvst no spanning-tree optimize bpdu transmission spanning-tree extend system-id ! vlan internal allocation policy ascending ! vlan 2 name GreenNet ! vlan 3 name...

No firewalls on the switch. The ports are on the same vlan. My desktop ip is 10.111.x.x. But whats got me confused is from the same desktop, i can ping 10.1.10.1 & 2. Both ports are configured exactly the same with the access to vlan 119. Thanks.

Hi, I have a cisco 3550 with 4 ports used to connect 4 different devices (10.1.10.1/2/3/4). I can ping all 4 from the switch without a problem. I can also ping all 4 in a workgroup environment using a small 5-port switch and a laptop. But from my desktop, i can only ping 10.1.10.1 & 2. I...

Hi, Need some (steps) on how to proceed with this scenario. We had Exchnge 5.5 with user emails from 1/2002 til 5/2005. We then got a new exchange 2k3 server and exmerged all of the exchnge 5.5 data to the new one. On 1/1/06, our new exchange server storge array died(server is fine). So...

yelworcm, We added a larger HD and moved the DB to it. Eversince then, Ghost Clean has been showing up. It never showed up (atleast did'nt lock any users) before.

Hi, What is ghost cleanup? Can it be stopped? Approx. 10am for the past 2-3 days it has been running and locking the DB so none of the connected users can retrieve data. Any help is appreciated. Thanks.