Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by dholmes45431

  1. dholmes45431

    MAGIX PRI Incoming Problem

    Update, Working with CO (SBC-who does not/will not support 5ESS emulation on the DMS) on PRI settings to resolve why my 100D-Legend card works and my 100DCD-Magix does not support incoming call but outgoing is fine. Currently have NTNAPRI protocol, and the L1 flags are set to yes (SBC claims...
  2. dholmes45431

    MAGIX PRI Incoming Problem

    Update...phonesrus' last post correctly states the setup. Currently verifing protocol setup with the CO. Thanks for the replys
  3. dholmes45431

    MAGIX PRI Incoming Problem

    The plot thickens... Tried calling another Magix extension by dialing out through the ARS (dial 9+full 7 digits DID of another extension on the system) Got the typical telco 3-tone error signal then the automated message that reads the number back and states that the number is not in service...
  4. dholmes45431

    MAGIX PRI Incoming Problem

    Ok, back to basics CO sending 7 digits, Legend (first print out) working in this configuration for years. All CO digits sent are of this format: 91064XX Internal extensions are in the 400's (except for remote access ext 666) Extension 400, 666, 401, 402, 403, etc are valid with handsets in...
  5. dholmes45431

    MAGIX PRI Incoming Problem

    MM, No amber light on incoming Yes, in the test setup I have a few extension numbers with phones that are in the correct range as verified by internal call between them. Internal calls will light the amber LED
  6. dholmes45431

    MAGIX PRI Incoming Problem

    Dizzy..yes I thought of this before and had tried it last week, just finished doing it again to reprogram channel IDs from 1 to 23, and retried, still not inbound, outbound works fine??? Caller ID says Network Busy and fast busy tone. Thanks for the idea
  7. dholmes45431

    MAGIX PRI Incoming Problem

    phonesrus...I literally have both new and old(operational) systems side by side, just moving the operational PRI between systems to checkout the new Magix configuration BEFORE moving it to the new building...therefore the problem is isolated to the new Magix configuration MM...I agree symptoms...
  8. dholmes45431

    MAGIX PRI Incoming Problem

    Have a Legend R7 on a PRI with rock steady performance for years, about half of the system is comprised of Magix modules in clam shells, including the the processor as a result of office growth. Moving to a new building and using the opportunity to upgrade to Magix carriers, 100 DCD, 016, more...

Part and Inventory Search

Back
Top