Recent content by demys80

Thanks a lot,I'll try it when possible!!! Have a nice day!!!!!!

Hi everyone!!!! exist a method to have see block of analogic line???with digital line you can type blfdp:lim=X, but I don't know,if exist,a command for analogic extensions!!! Help please!!! thank 1000!!!

LC numbers are used for comunication between CISCO IP and MD110! Yes,it does!!!I want to add a new range (5200&&5399) and use this range with new ISDN-Conn!!! I hope that you can help me,thanks again!!!

Sorry for my English,I'm Demis!!! I have a problem: I must add a new range of internal number and associate it to a new ISDN line (30 channel). Please give me step for make this!!! My configuration: <nadap; NUMBER ANALYSIS DATA TYPE OF SERIES NUMBER SERIES...

Thanks a lot....what is the unit for GH in BC10???? have a nice day!!!

Good Morning forum, I have a problem with GHGRI:When I call the group says to me that the members of the same group are absent and resolves the single problem removing every element and to insert it newsly.What is the unit of program for restart group Hounting Data??(realese BC10). Thanks and...

Hello, I have the following problem with Q-SIG between MD110 and Cisco (mod.3745):frequently happens to me that logon falls and I do not succeed to carry out calls (from MD to Cisco and viceversa), on telephone DBC212 appears:via economic occupied or the engagement tone is felt not ago but...

I have a simple question for you!!! Exist a meter for telephone 3212 or 3213 telephone???I want to count how many calls recived a single terminal!!! Please help me,sorry for my bad English!!

thnks Patcher for information!!!

Good morning, I have the following problem: If I digit common abbreviated number of MD110 with Cisco phone through Q-sig channels I can't see the explosion number of COMMON ABBREVIATED DIALLING FACILITY DATA on Cisco dysplay (COMMON ABBREVIATED working) is it a problem of MD110 configuration...

No....you're not stupid, probably I'm not precise!!! are there any parameters beyound CDINI or PELPI for set diversions????

I'm not clearly, I want diversion for flow (0371/465.001) not for single extensions!!! I hope that you can help me,thanks again!

Good morning, I have the follow problem: I don't know the commands to see generic diversion on busy or absent (not cdidp on specific terminals). Example: I want that incoming call 0371/465.xxx on busy or absent go to 0371/465.111 (P.O.). I hope to be clearly!!! Thanks for attenction and sorry...

The solution of problem is: set ADC of digital or analog (kscac or excac)extension at 000000010. Thanks child,have a nice day!

I have tried,It's not the correct solution!!!