Recent content by demea26

UPDATE - Reset the Hunt group and it works.

Hi. I am tasked with configuring some sort of ‘Automatic Call Distribution’ with Call Manager 4.1.3. Here’s a brief overview of our configuration... PRI from Telco-->Cisco 2811 voice router in office A-->LAN-->Cloud-->Cisco 2811 voice router in Office B-->LAN-->Call Manager server We have four...

Hi all, I searched the forum for related items, to no avail. I am trying to get any type of job to run using Brightstor v.11 and W2K3 Enterprise edit. For any type of job I submit, I get the popup: Please mount any media. Or Please mount media "medianame" If I cancel, (the only way to quit...

I'm having the problem, but only when the Cisco IOS firewall v.12.3(2) is up, which isnt good for obvious reasons. When disabled, everything is OK. Error message, 550 not local host accupac.com, not a gateway. Its really driving me nuts because people are saying that the outgoing server...

I'm having the same problemthat other users apparently are, but only when the Cisco IOS firewall v.12.3(2) is up, which isnt good for obvious reasons. When disabled, everything is OK. Error message, 550 not local host accupac.com(or any domain other than my own), not a gateway. Its really...

I'm having the same problem, but only when the Cisco IOS firewall v.12.3(2) is up, which isnt good for obvious reasons. When disabled, everything is OK. Error message, 550 not local host accupac.com, not a gateway. Its really driving me nuts because people are saying that the outgoing server...

Duh. I had the far jacks wired for B and the patch panel wired for A. Doh! Too much on my mind I guess... Thanks guys

This is odd. With any other switch that I had used, you just power it up and plug in node ports and done, networked! The only port lit up is #1, too. If I plug a cable into another port, 2-24, nothing. What gives? Thanks for all your time, guys

I erased the current config by holding down the mode button. Now, I know the default ip address of the switch is 10.0.0.1, does that mean if I make no changes to the switch and just plug and play, my network ip scheme needs to be changed as well? Just curious

Heres the current config. Ports 5-24 are the same, but I didnt copy them: Thanks Vlan1 is up, line protocol is up Hardware is CPU Interface, address is 000f.24bc.43c0 (bia 000f.24bc.43c0) Internet address is 192.168.10.30/24 MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, reliability...

Its a brand new out of box switch. Should I erase the current config then?

I'm new to the 2950 switch, which I got a great deal on and is the reason I bought it. I'm migrating from an unmanaged 3com 24 port. The question that I had is that I set up the switch using the express setup, configured the IP address, hostname, passwords, etc. and I have no connectivity from...