Recent content by deinterlect

Guys again i must thank the individuals that contribute to this forum. I was able to get the E1 up and running. Had to make 2 changes. [ol 1] I changed the link descriptor to inverted on audio and data as suggested by kwbMitel and p011406 [/ol][ol 2] I changed voice compression to ADI [/ol]...

Forgot to mention this is an R2 E1

I am having some trouble programming an E1 NSU. Right not i am able to dial and receive call. However when the receiver is picked up all i get is noise on the line. Does anyone have any basic settings for programming the NSU

Hi good day all, I have been having an issue with an sx 2000 where call to extension on the system drop. Its also affecting calls coming into the system from the trunks. The call simply just cut off during a call. Your assistance with this matter will be greatly appreciated. Thank you.

That's true. Does anyone know what the channel monitor short code does and how it is programmed?

My point exactly. I have a client that is requesting this feature for their organisation. Apparently a competitor offered them this solution and told them that it could be done with a PBX system they install. I just want to make sure that this sort of thing cannot be done

amriddle01 Can it be done with any PBX system other than the IP Office.

Can it be done with any PBX system other than the IP Office.

Firstly is this for when the person is on a call. I would like to activate the microphone when the phone is just sitting there on a desk. Secondly is there a short code to activate this feature.

Can you activate a microphone on an extension from another phone without that extension knowing that the microphone on their extension is activated.

Where is that found under customer data??

Hi everyone is there a way to quickly find an extension on an SX2000 system instead of having to scroll through the entire list to find an extension.

Found the problem. Calls were being sent to a SCN link that also had line groups 0.

All lines are POTS lines in outgoing group 0. ARS is set to send calls out on group 0. Outgoing calls are allowed when the system is first rebooted for about 5 minutes then it goes back to saying waiting for line.

Running an Avaya IP Office version 7.0.12. It allows the extensions to receive calls but shows waiting for line when the extension makes a call. All the lines show idle on SSA. On call status calls show ringback but does not select a trunk.