Recent content by Deftyone

10-10 numbers are used to bypass your primary long-distance carrier. If for example you're long-distance can't complete a call to specific long-distance location, you can try inserting a 1010 number for another carrier to complete the call. In your case, if you ever had a call make it to the...

I have a configuration whereby calls flow through three VDNs to access an application behind Voice Portal. The first two VDNs have 'VDN override' enabled (y) and the last VDN has 'VDN override' disabled. The last VDN is the number Voice Portal uses to identify the which application to use...

That's software corruption. If it's only four months old, you should be able to open a ticket with Avaya's corruption team.

Have you considered using a vector routing table instead? 1. goto step 5 if ANI in table 1 2. wait n 3. route-to 6666 4. stop 5. disconnect change vrt 1: 442-765-4543 (Joke caller)

We are upgrading to AVAYA Release 5 IP Agent. We are getting 500 Agents We currently have 500 Release 4 IP Agents. We are going to stage the installation of R 5 Agents. 100 per week. The question is can R4 agents log in using the R5 RTUs, so that we can provision the R5 agents over time Thanks

I'm trying to setup a 2610 that is on my home network so that I can access it from the outside world. I have the 2610 connected to a SOHO(D-Link) router. I can access the 2610 from any other device on the home network. The 2610 e0 address is assigned as a DMZ host on the SOHO. I tried...

Try display circuit-packs and make sure there's no translations for any circuit packs in C. Also, do a change cabinet and make sure C carrier isn't still translated as a port-carrier Just a thought.....

It was an S8700. The answer was: Press transfer dial the MM hunt group number press *, #, #, desired extension release call

When is a RUK kit needed for an Intuity Upgrade? Can you perform a RUKless upgrade from a MAP40 r3 1-55 to a MAP5?

You may have something bussied out on the standby side. If you "status PNC" you should show warnings if there's smething bussied out. Confirm that at the top of the page "Standby Busied" says "no" Do a display errors and specify error code 18(busy condition). If you have any PNC components...

Just installed a Modular Messaging System. This may be a dumb question, but any assistance would be appreciated. Can someone explain how to transfer callers directly to a Modular Messaging mailbox without ringing the PBX extension?

I installed a PDM type data-module on an S8700. Testing proved that it does work. Documentation says they are not supported. However, that does not mean they don't work. We need to maintain these PDM's for a short period after the upgrade. Fortunately, it looks as if we can. Regards,

What data-modules must be removed when migrating to an S8700. I know the wcbri's are supported, but will the pdm data-modules still work in the S8700?

Thanks Chris. However, I shoudl have specified hardware minimum vintages. That's what I needed. If you're interested: ftp://ftp.avaya.com/incoming/Up1cku9/tsoweb/media/minhardwarevintages.pdf You may have to right-click this link and choose copy.

If you have tenant partitioning turned on, you administer your music source under "change music source" as opposed to "change system-parameters features". You could then assign each Business to their own Tenant Partition, and specify unique music sources for each Partition. That's the only way...