Recent content by definityman

Hi Nicolas, i know there is a test to disable on the bri card to not check for the layer 1 stable. Honestly, i came across this issue a long time ago and i can't remember the number of the test. Anyway, this can only be disabled by init so, you need to log a ticket to avaya and ask them to...

Hi Mitch672, the autonegotiate is a setting that neither avaya suggests. It's always strongly recommended to have speed and duplex fixed on the same setting on both sides of the connection, even if you are using a direct connection. Cheers

Well, it seems that the s8400 is loosing the control of the G650. i'd say the best option is try to replace the SIPI, but before that, verify that the speed of the control lan interface on the s8400 and the network interface on the SIPI card are both setup as 100mb full. The loose of connection...

Hi mate, not 100% sure but it looks like an errore related to the control network. Can you see all the boards doing a list conf all ? What is the output if you do a list ip-server interface ? Cheers

Thanks Zen216, the programming is not an issue, the issue is how to get the layer 1 activated. All the programming for the routing is already in place. Cheers

Hi all, i need urgently help. We are implementing an integration between an s8300/g700 cm 2.2.0 using an mm720 ( fw 8 ) and a rightfax 9.3 using a brooktrout tr1034. I've set up the tie trunk and the bri board , configured as network, protocol etsi and tei 0. The issue i have is that i'm not...

Hi Mate and thanks for your reply. I'm in Italy and the board on the rightfax side is a tr1034. Despite i'm an ACS, i'm not able ( but neither the avaya tier 3 engineer that has my case assigned ) to get it out. If you have any contact i can give a call ( speaking english is not a issue ) to...

Hi all, i'm comimg across some troubles with an integration between an s8300 cm 2.2 using an mm720 fw 8 and a rightfax server version 9.3 . I have configured correctly the trunk and bri board ( avaya has confirmed cause i have a ticket logged for this issue ) but whenever i do a status bri port...

Hi moev99. what about ip-network regions and ip-coded sets ? I have done several IA770 install starting from cm 2 to cm 3.1.4 and as long as i know , the IA770 has to be on network region 1 with codec set using g.711 MU . Hope this helps

Hi, have you checked that default gateway on the S8300LSP is correct ? Cheers

Hi all, i've got my ACA certification last week and now look forward to go for the ACS. I've made several researches over the web but were not able to find any study guide for that. Anyone can help ? Thanks

Hi all, te following to let you know the passing score for the 132-s-100.3g is 58%. Passed with a score of 84%. Cheers

Hi all, next week i'll go to apply for my ACA exam. I was wondering if anyone knows which is the score to pass the exam ( outside the US ) and if you know where i can get some study material to use to prepare that. Cheers

Hi there. I think basically you need to create a data module with an extension configuring correctly country codes and TEI as well and for sure assigning an extension number to your data module. It's the same you can do with an old TN556. Cheers

Hi mrjedi , have you done the upgrade from the web interface from cm 1.3 to cm 2 ? As long as i know, the old S8700 that came with the CM 1.3 preinstalled have a bug where in the bios, the boot sequence is HDD - CDROM. I think that the only thing you should try, even if a bit difficult , is to...