Recent content by dct

Followed the procedure from the manual, but coudn't get this switch to factory reset. It reloads quickly and the power LED is green. It seems that all the 24 10/100 ports are OK, but I can't get the web mgmt page and/or the 1Gb ports running. The last operation I did on it was to create VLANs...

Hello! 1st be sure that the following command lines are included in your server's AUTOEXEC.NCF file: load smdr load tsa410 load tsands These modules are needed by the accel agent. Type the following command to see if they are presently loaded in memory: modules tsa* If they are not present, load...

Please read the agent logs, job logs, event log. We can't figure out what's wrong with this server without further informations. Regards, D. Croset

Tried to exclude license file andor directory, without success. I think this is caused by the way the agent or the backup server reads the NDS. It seems that the job scans the whole NDS caontainers, ignoring the exclude statements. Hope that Veritas corrects this this year... The only problem I...

Hi BreadKnife! I also got a Bad Media message, inserting an Arcserve-formatted Ultrium tape. Erasing the tape rendered it usable for BE 8.6. Other AS-initialized tapes worked fine in Bexec. I don't know if this is a miracle, but it worked! Please double-check your scsi chain, IDs, cables and...

I'm really disappointed about Arcserve 2000 / nwagent on NW5.1 or NW6. I thought last week I found a functionnal NW6 SP1- NWagent 02/2002 version combination, BUT after a minor modification in my backup job (some locked files exclusion), the NW6 server abends in libc.nlm (caused by an invalid...

It seems that we cannot exclude IPX/SPX in the nwagent. In the asconfig.ini file, add "IPAddress=123.456.789.abc" in the [netware Agent] section; this statement will force the agent to use this specific address, assuming you can have two or more IP addresses defined on your server...