Recent content by dcross

Your TSP should look like this. REQ prt TYPE tsp DSL 68 0 4 0 OPT USID 1 MPHC NO SPID 92043322170101 DN 2217 0 CT DTA MCAL 4 CLIP YES PRES YES COLP NO TRANS NO FEAT HTD FND SFD CFTD MWD FBD CFXD DNO3 DNDY SSRV_NI DFDN 2217 USID 2 MPHC NO SPID 92043322180101 DN 2218...

Is it the ELAN address of you Call Server?

Target lines are programed, SIP URI Maps are the same as sig server, no firewall and SIP static IP set up in NRS. What am I missing?

Tried static did not work.

Looking at NRS under gateway endpoints call signaling IP is Not registered. I have set up the gateway endpoint Dynamic SIP, transport is UDP and Port 5060. On the BCM50 SIP Proxy Domain is the Domain listed under the Service Domain in NRS. I added a Outbound Proxy on the BCM with the Domain...

I have that set up on the CS1000 and in NRS.

Has anyone networked a Cs1000M 4.50 with a BCM50 using SIP trunks and MCDN? I'm looking for the set up on the CS1000 and the BCM.

Timmy?

Yes I am.

On the user set due you have a AST set up?

Yes I know Overlap Receiving & Overlap Sending of what?

What dose OVLR and OVLS on a DCH? NTP's dose not have a good explanation.

We our trying to make a tap cable to read Qsig messages for MWI, so we can send DTMF messages to trun on and off MWI light on a siemens 3700 gateway set. The 3700 is not Qsig compatable.

Dose anyone have the pinout of a NTCK80 cable DDP Card to MSDL Card or the 26 pin conector on the DDP Card J6 what each pin dose.

I'm being told that the Siemens need to have a DCH for each PRI. What I'm hearing is there is no problem having 5 PRI's with 5 DCH's in the same route with calls coming IAO on the route.