the exch side of the qsig card is a network card and the firmware should be 2.07,any lower than this is known to cause lockups,you need to get your maintainer to check this as the software required (GEDI SCRIPT IN PROCOMM)is as
far as i am aware only available to siemens employees.
hope this...
the command you require is stac (set trunk access)
you will be prompted for tac,try 1 this is usually 999 calls only.
tac 0 will usuall bar all calls.
Darren (siemens commisioning engineer)
what software level is your switch running and i will try and sort out a command manual for u
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.