Recent content by daytrippin

Thanks for the replies. I had to access the statup config via the ROMMON prompt to edit the enable secret, as described here.... http://www.cisco.com/en/US/products/hw/routers/ps221/products_password_recovery09186a0080094773.shtml Cheers, Nick.

Hi Burt, Thanks for the advice.... I thought they had mis-typed too and I've asked them to try again but so far still no joy. The only difference is I am in the UK and they are in Poland, could there be some sort of key mapping peculiarity, the secret includes characters such as '@' but this...

Hi jneiberger, Thanks for the reply but could you please expand a little, are there some tools you recommend? Cheers, Nick.

Hi, I have an 1841 router at another companies site which we use for a VPN connection to our kit located there. They have updated their public IP gateway address and so I need to update the config on the router. As the changes have already been made by their ISP I'm unable to access the...

Thank you for all the advice.... I have tried to call Cisco but my router is out of the years warranty and they wouldn't even let me log a call for advise. I have re-seated the card a few times just to make sure that it hasn't come loose. The tftpdnld -r option was bang on! Nice one. This...

Hi, Any help with the following would be much appreciated.... I have an 1841 router which will not load from the flash card. device does not contain a valid FS boot: cannot open "flash:" boot: cannot determine first executable file name on device "flash:" The router will only then boot in to...

Hi, I am restoring files from a series of backup tapes and for some reason some of the files keep the restore date rather than their actual mod dates or backup dates. This is not too much of a problem but if I could change the dates to match the other files it would make life a bit easier. Is...

Thanks 605, This device is correct though and it works on the other identical O2 box. The olny thing I can think of is that the SCSI card has some hardware switches or jumpers??

In need of more help... ! I have two O2 boxes and two DLT tape units, adic DS9800d, but I can only get one set up working. The DLT drives have an LED screen and has Compressed written in the top right hand corner. This is the same for both set ups until after they have booted up and this...

Thanks for the help, only another 997 tapes to go.....

OK, I've found a way to recover all data from all save sets on the tape as we go... scanner -c clientname /dev/rmt/tps47d6nrnsv -x uasm -rv This is working at the moment but it was using a tape that exists in the index, about two thirds of the tapes are not indexed so we'll see if they work...

Thanks for the help 605. Is this the Tech Bulletin you mention or is there one on this site? http://portal2.legato.com/resources/bulletins/001.html#recycle I have tried to recover some data by running the following command, without fully understanding the uasm switches! scanner -s ssid...

Hi, I've been given the task of retrieving all the old data from a large number of backup tapes which were created via Networker ver 4.2.5 running on an IRIX box. These tapes are between 4 and 10 years old and I have no experience of Networker! Using 'save set recover' I can see the save...