Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by dawsomi
-
Netscreen Remote behind NAT
Thanks John! We set ours to 1350 and all appears to be working great. Thanks Again! Mike- dawsomi
- Post #8
- Forum: Security, hacker detection & forensics
-
Netscreen Remote behind NAT
Yes, Dial-up is traversing the Netscreen. Tested Netscreen Remote client from both dial-up into ISP (No NAT) and Broadband with NAT. I will test tonight after making the set flow changes. Thanks, Mike- dawsomi
- Post #5
- Forum: Security, hacker detection & forensics
-
Netscreen Remote behind NAT
Thanks, I will make the changes and test it out. Juniper\Netcreen CSO gave me the same answer except they suggested: set flow tcp-mss 1200 set flow max-frag-pkt-size 1140 The max frag must be 60 bytes less than the mss value Question though, is this issue specific to NAT Traversal? The reason...- dawsomi
- Post #3
- Forum: Security, hacker detection & forensics
-
Netscreen Remote behind NAT
We have recently implmeneted the Netscreen-204 and have implemented Netscreen Remote for VPN and everthing seems to be working properly except when the remote user is using NAT. We have enabled NAT Traversal and are able to Ping devices through the tunnel; however Outlook synchronization and...- dawsomi
- Thread
- Replies: 8
- Forum: Security, hacker detection & forensics
