Recent content by DaVinici

where can I find a copy of DSA 2.0

thank you for your info

where would I find a list of Definity common control cp's for all the releases.

what is needed to upgrade a g3v6 to v7 or v8...a processor change or netcon card....any ideas..thanks

are you refering to the ox16 mlx or the 0x16 t&r pack. what release of ti card is the 517m15.

anything special I need to know about installing a PRI ckt. what to look for....possible problems...etc.

Now for the next set of q's. If the customer I have wants to change from the 2way-DID T1 to a PRI...can I use the same 100d card and I did notice a set of parameters to program for the PRI ckt. Will I have to remove the translations of the T1 first. I have never installed a PRI ckt...so any...

got it...thanks for all your help!!!!!

so with the PRI ckt...there is no extra programming for Call ID...it automatically starts.

as far as I know it is a T1.

2 way DID

With a PRI ckt...any special programming needed to get Call-Id...or does it automatically send the call id info to the sets..my customer has a At&t T1 ckt used for DID's. Right now no call id info is being sent...At&t says their ckt should be doing so....any ideas..thanks. The switch is Legend...

thanks for your info...good stuff...I suspected as much... I prefer the Legend way of doing restores.

Is there some golden nugget of info on how to take R3 backup translations and attempt to restore to a higher release processor.

The Merlin 410, 820 series required 4 pairs...if you did not care about the voice over the IC...you could get away with 3 pair.