Recent content by dannoWI

Succesion 3.0 Am I just being impatient here? I had the error on EDD failure telling me to do a ABKO. I started a ABKO and it seemed to go fine then it told me to put disk 1 back in (I only used 1 floppy)and typed 'a' to continue. It appeared this would do a verify maybe but it has been an hour...

Call Manager 6 - Unity 7 - and Nortel CS1000 rls 3.0 with a QSIG PRI between the Nortel and the CUCM. Problem comes when trying to lite MWI on Nortel phone. Message is left in Unity Mailbox and an attempt is made to send MWI but the dchannel message always comes back with "Cause #21 - Call...

dannoWI (IS/IT--Management) Oct 16, 2008 Scenario: External PSTN call comes in on Cisco side and routed to phone A on Opt.81 over QSIG trunks. Phone A transfers call to Phone B which is back on Cisco side. This works fine but will leave the 2 QSIG trunks tied together for the duration of call...

Scenario: External PSTN call comes in on Cisco side and routed to phone A on Opt.81 over QSIG trunks. Phone A transfers call to Phone B which is back on Cisco side. This works fine but will leave the 2 QSIG trunks tied together for the duration of call rather then dropping. Cisco Rep says...

I can't even get this to copy so that excel will read it. It shows headers but no data. It's a small world, but I wouldn't want to paint it. Steven Wright

I cannot print an entire abbreviated dial list without going page by page. Is there a way to do this? It's a small world, but I wouldn't want to paint it. Steven Wright

I found the answer to this lies with the cell company. There is something with our main number when they get that as the clid.Other cell companies don't have this problem. And it is not a problem if we change the clid. It's a small world, but I wouldn't want to paint it. Steven Wright

CS1000 rls 3 We do allow forwarding to cellphones and in most cases it works fine. The 1 problem is if the cellphone goes unanswered the celluar voicemail system doesn't answer the call in answer mode. Instead it asks for the your number. This happens if the main number is sent out as the clid...

The MDR seems to be setup, I can telnet into it. The OTM uses the same connection script as the dialup MDR which are working. I have no manual and Avotus is no help without maintenance contract. It's a small world, but I wouldn't want to paint it. Steven Wright

I have OTM 2.2 and a MDR2000e buffer box. I can telnet and ping the MDR2000 however OTM gets a connection error when I try to collect data. The configuration has been set for ethernet with the correct IP. Any idea what may be missed? It's a small world, but I wouldn't want to paint it. Steven...

That's what i needed, thanks so much. It's a small world, but I wouldn't want to paint it. Steven Wright

Thats the problem. No manual. It's a small world, but I wouldn't want to paint it. Steven Wright

I found the IP but Telnet fails. Is there a certain port or other command needed? It's a small world, but I wouldn't want to paint it. Steven Wright

Thanks acewarlock I have that manual but don't see any mention of the IP settings. It's a small world, but I wouldn't want to paint it. Steven Wright

The OTM being offsite from this OPT81 is not direct connected. The MDR2000 will store the records till OTM retrieves them. It's a small world, but I wouldn't want to paint it. Steven Wright