Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by daniel69

  1. daniel69

    using paralel port in VB6

    thanks javaguy, I'm converting from serial to parallel in my angular sensor board. So as you say, should I use MScomm instead converting to parallel and using lpt? I suppose, I have to set the serial protocol ( start bit , data, stop...) becouse my board doesn't actually do it. It only give...
  2. daniel69

    using paralel port in VB6

    sorrryyyyyyyyy!!!!!!!!!! Can I explain a little more what I want?, I see you are an expert in these topics. I'm creating an external board which converts an analog measure( angular sensor) into digital form (12 bits) setting a ready signal when data is available for reading. I have a register...
  3. daniel69

    using paralel port in VB6

    That's the thread I read before, but there it is not said how to set the voltage for the pins, or how to control the port in a word. Thanks...
  4. daniel69

    using paralel port in VB6

    Can anybody explain where to start in order to use parallel port in VB6? I'm trying to read 12 bits of data from a external board when a enable signal is activated, then depict it on a form. I read a thread about voltage level in parallel port (2 jul 2003). Hypetia answered a question about...
See more

Part and Inventory Search

Back
Top