Recent content by daddybadger

I can obtain 1.6.1 but this is for the EU market not sure if that will work. Your Forerunner link is here you may want to contact them -> https://frtinc.com/nec-channel-partner-support/

use a trunk key and assign as the VE in enhanced mode, you can then program this as an outgoing call key when pressed. This is the only way I can think of doing this as adding a 'virtual dss console' does not work, or rather I cannot program *03 Virtual on a dss key.

Discontinued as well as the ncp that's end of life and Panasonic have pulled out of the pbx market. Upgrade to a NS and get the v9 licence free.

Wow not worked on one of those for years but if memory serves me correctly you need emanager or something like that. I know that had compatibility issues after windows 7, don't have this software but most likely available on the web.

I connected SL1100 via SIP trunking, probably work for a 2100 - I have a document that you can follow its most likely f-route or something like that you're having issues with. SL Networking

Only way I thought was via Web Pro on user1 or did I type that incorrectly. Either way wont upload. @The mitel guy I can possibly replace the SD, its used for VRS not sure why they have SMDR as they don't even use the MyCalls or at least as far as I know.

Greetings - SV9100 CP20 for the 2nd time the SD card will not allow to upload any files as reporting its full. I have deleted the SMDR buffer and rebooted but this did not resolve the issue. I previously went to site, removed the card copied the contents reinitialised and reinstated the backup...

If you mean a DDI (or DID) then yes providing you have a direct dial to allocate.

Setup a NTP server if it has access.

Not sure if you can harvest some info from the SD card, unfortunately I think it gets overwritten as there's an expansion card for SMDR storage.

84-39-05 set to mode 3 make any difference?

Tried a different web browser? Is the filename invalid?

Never seen a 76xx on a TD, only on a TDA.

Those pesky key phones that are compatible with the relic Kxt308/616 work on the TD but you need to disable the XDP port. This applies to UK.

You can use slt/analog/2 wire/pots on this relic. The 4 way RJ 11 from the system should be terminated red green (pins 2/3) yellow black (pins 1/4) and it is the red green that is your analog pair. Programming wise there is a switch inside the cabinet that slides over and then you program...