Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Cytranic
-
Cisco Routing and NAT help
I need all ports both TCP and UDP to be sent to 192.168.10.3. My VOIP card on the PBX requires that all ports be open. Is this possible? -
Cisco Routing and NAT help
Also to add the Serial 0/0 is irrelevent as this is setup and working fine. here is my router config WEST#show running Building configuration... Current configuration : 1189 bytes ! version 12.2 service timestamps debug uptime service timestamps log uptime service password-encryption ... -
Cisco Routing and NAT help
Here is my setup: teh Serial 0/0 is connected to a point to point t-1 to our remote office. We use this T-1 stricly for Voice over IP ONLY. 192.168.10.3 is our VOIP Proxy which the phones connect to, and is connected to FastEthernet 0/0 (192.168.10.3) Now since this is a point to point... -
Cisco Routing and NAT help
Well I've masked my ip address for security sake. However the mask is 255.255.255.224. Do you need the correct IP address for you to diagnose? -
Cisco Routing and NAT help
I need help with a cisco router & nat problem I have. My setup is as followed. Serial 0/0 10.0.0.1 ( Point to Point between an office.) Fastethernet 0/0 192.168.10.1 ( Internal Local Gateway) Fast Ethernet 0/1 203.207.17.135 ( Live IP address) Basiclly I need all traffic and protocols on...
