I have a Cisco 806 Router I would like to know how to have the DHCP server of my cable inet assign my e1 (the port plugged ingo the cable modem) 5 IP address instead of just 1.
you have ALOT of extra lines in your running config I would 1st erase the running config and try programming it from scratch another thing I would try is setting clock rate on both side (yes I know its not required BUT I always do it to be on the safe side) last thing I have never set my serial...
I am looking for a SNMP enabled Network Monitoring tool that will send alerts via email and sms and I would also like to to be able to grab information from cisco routers log and have the ability to graph it. Anyone have any suggestions to what I should look into I would only like to stick to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.