Recent content by crazylife

Hi Yep pretty sure its the same method. I think since about 8.6 its been this way, but can't be sure. Hope that helps.

A note to anyone else reading this. I have looked into the 32 bit app on a 64 bit OS and have come up short. Microsoft say it is possible in one technote and in another say its not. I Think it boils down to the App and the installer, if they fit the Microsoft model it works, if not then you...

Hi Steve Thanks very much. I had just come to the same conclusion! It seems a bit silly to me that Symantec can't provide a 64 bit version. Dumps it is :-(

Make sure you have the hotfix for device drivers installed. this may help. It is a Veritas/Symantec hotfix. If you do phone Dell I think the only thing to ask is "does the drive support hardware compression". I assume that it does, but you just never know! Get the latest Veritas drivers and see...

I have seen this before and it has two causes. 1 Bad tapes (clean the drive as well) 2nd, the tape drive is on its way out. Maybe if you can reduce the throughput to the drive it may help. Also try a smaller backup and see what happens. In the past I have found when the drive is on its way out...

Hi You need the remote agent license installed on the backup exec server (whatever server you installed the main 10d on). You can get to it from the tools option, serial numbers and licensing I think. Add the license there and it works. You can install any option on any machine but without the...

Hi all I am having problems installing the Oracle Agent for 10d with SP2. The remote server is a Win 2003 with 64 Bit version of the OS - BE server = Win 2000. Following all of the Veritas/Symantec docs, which are not very good for the Oracle Agent, all I get is an error that says the exe is...

Hi all I have a 2000 Terminal Services Server that when I go to the Client Settings config tab it has the disable drive mapping check box checked but greyed out. I need to map a drive and can not remember where to change it. The server sits in a NT4 domain, so OU etc isn't an issue. Many...

Hi All The merak server died this morning. Power failure during backup! Any way it lost its domain info, not a big deal if I can get back in. It normally has an admin password to login to the Merak Mail administration interface. With no primary domain the username and password does not work...

Actually it is the login information in the citrix program neighborhood. Go to settings, logon information. Radio button for local user, no option to check the pass-through authentication. Is there a registry entry? Also only a problem for non administrators so far, could be that the user does...

Hi All On a clean install (and on upgrades) the the latest ICA client does not give me the option to tick the Passthrough Authentication box. It is greyed out all the time. Any help would be great RThanks

Hi I have the latest driver from Dell, seems to be the same as the original driver. No luck yet. Thanks for the post.

Hi all I have an inspiron 5100 Laptop that was working perfectly but now after a reboot I lose the broadcom network adapter. It is just ! marked in the device manger. I delete it, scan for hardware changes, the PC finds it and installs it. No worries at all. It then works without a problem...

Hi All Thanks for your posts. It turns out that there is a problem with the SAM. I have deleted it, recreated user accounts and passwords and all is well. Very bizzare as local logon with the accounts was fine. However it would seem that once upon a time this server was part of a domain but was...

Dear all I have one Win 2000 Server at a remote site with no domain. TS is a great way to control this server for admin tasks etc. I have set up TS on many servers so am not a novice, however I can not logon to the new TS server. I connect to it, but it gives the very standard response that the...