Recent content by Crawebci

For everyone who has this problem of something like it, I figured out how to fix the problem I was having. All I needed to do was go to the Devices tab on the top of the screen, right click on each Backup-to-Disk folder on the array that was directly connected to the server running Backup Exec...

I installed the Adpatec driver for the card and there is still no change. The firmware version that is installed into it is the latest version also. Everything has been updated and it is not working. If there is anything else that can be suggested, let me know. Thank you.

Actually, we are not using a tape device for backups. We are using a Promise VTrak M500p in a RAID 5 setup. It has 15 hard drives we are using to save our backups to. So we have all our Backup-to-Disk folders on the array. The Adaptec SCSI card 39160 is connected to the VTrak M500p with the...

I updated the firmware for the array, but I am not sure about the RAID controller. The firmware update for the array did not do anything. I have an "Adaptec SCSI card 39160 - Ultra 160 SCSI" controller in the server. The latest update for it was on 5/30/2001 on the Adaptec site. The driver...

I moved the Backup Exec installation from one server to a new server. We have a SCSI array attached to this new server, which is where we would like to save our backups. We have the Backup-to-Disk Folders setup. The first time I run an inventory on any Backup-to-Disk folder it is successful...