Recent content by CPaul123

We are using a 2851 and using a VzB VOIP solution. In our other 8 centers we have a firewall performing the NAT but this was the first center to go live so we did the NAT on the router.

These NATs are for our VOIP phones. 10.41.4.5 is one of the phones. This phone needs to be NATd in order for it to work however in order to connect to our NTP server it needs to keep its original address.

Does anyone have any experience with Cisco GET VPN?

I am currently NATing all outbound traffic behind my Multilink123 interface. However when I try to access an internal device the addresses are still being NATed. How can I create an ACL not to NAT my internal traffic? Here is a copy of my config: ip nat inside source list 98 interface...

one other trick is if you know the ip address...ping the ip address and then do a show arp...this displays the mac address..then you can do what jdeisenm says to do...

this is in an internal network...not an edge device...

I want to remove the default route but dont want to impact production...

Is there anyway to log what is using the default route as opposed to the static routes in a 7200 series router? thanks

thanks for the info...i was looking more for something like a cisco router interace. this would display CRCs and input errors.

Unfortunately thats not the case in my situation...I have six switches in one general area that are upliked off of one an other and 2 that are connected via a fiber uplink...

the one closest to the the gateway router?

I have 8 switches...which switch should i make the root bridge?

Is there a way to look at the interfaces on the LAN ports to make sure that there aren't any speed and duplex mis matches? Any information would be greatly appreciated. thanks!

Multilink123 is up, line protocol is up Hardware is multilink group interface Description: Verizon Business MPLS Circui Internet address is MTU 1500 bytes, BW 3072 Kbit, DLY 100000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation PPP, LCP Open, multilink Open...

bur-verizon-r1#sh run Building configuration... Current configuration : 22480 bytes ! version 12.4 no service pad service tcp-keepalives-in service tcp-keepalives-out service timestamps debug datetime msec localtime show-timezone service timestamps log datetime msec localtime show-timezone...