Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by coxit

  1. coxit

    Call Manager Overhead Paging with Valcom 2006

    I have seen mutiple threads listed on paging solutions, unfortunately none is similar to my needs. We are using CCM 4.2 and have a Valcom 2006 control box. Our existing Avaya PBX is currently connected to this and it works fine. However, we are moving everything off of the Avaya PBX since we are...
  2. coxit

    IP Routing Question

    Here is the config on the switch: time: Fri Aug 3 2007, 08:04:52 EST ! #version 7.6(7) ! ! #system web interface version(s) set password $2$7oph$KJ2E1TeNHus6blKnYn6./1 set enablepass $2$XI12$ASp3Fq6I6dcyiPnJWCndc0 ! #system set system name 4006 ! #frame distribution method set...
  3. coxit

    IP Routing Question

    What should i make the gateway to be. The router interface 10.10.10.1 or the port connected to the cable modem which holds the IP od 68.105.207.27?
  4. coxit

    IP Routing Question

    I need some help on finding out what "ip route" statement I need to add to my Cisco 4000 router. I currently have my 4007 router connected to the Internet via CM on Ethernet 0 with the IP of 68.105.X.X. On ethernet 1 (10.10.10.1) it is connected to a Cisco 4006 switch. The only route I have...
  5. coxit

    Caller ID Name

    Thanks for the reply. The CO syas they are sending name, however, when I run a debug isdn q931 I still only see the number coming in. I am using a Cisco 3745 router with a NM-HDV2-2T1/E1. I just wanted to make sure there wasnt something else I was missing. We are using MGCP as well. I can only...
  6. coxit

    Caller ID Name

    I have a CCM 4.2 with a ISDN PRI protocol of NI2. Incoming calls are only displaying the number calling and not the name. Is there a way to get the caller name to display as well?
See more

Part and Inventory Search

Back
Top