Hey Guys,
Hopefully this is a quick and easy question. I have just been dumped with looking after our Witness servers, In the process of switching to Verint. I have been asked to increase the Inactivity timeout in witness to 60 mins.
Where and how is this done? Cheers for all your replies.
Check all the elements are actually in the UCM sercurity domain. Had problems before where the Sig Server and Call Server where in the UCM domain but the MGC's werent therefore they couldnt get Node files etc.
Hi guys,
I have a weird issue with CLID outbound on a 1000B. The phone will display the correct CLID when in local mode but when in normal mode the CLID will only be the extn number.
This is in Germany but the way with the mail system being in Ireland. I have setup a new CLID entry on the main...
Hi,
I have setup a cdn for my reception. This is to monitor stats etc. I have the night on the console going to a acd which is ncfw into a cdn, only because you cant put a cdn directly into nit1.
The agents login and they can take calls no problem. Whenever they transfer the call rings on the...
Check event viewer. Think the previous poster is on the right track with the IPSec issue. There was a known issue with IPSec service that it goes into trusted mode or something like that and will only talk to stuff thats trusted. ie nothing.
Look in knowledgebase about the solution for this I...
Hi guys,
Thanks for you replies. This has now happened to a 3rd server. Brand new out of the box. Set mailbox number length to variable and it wont let me add a 3 digit mailbox number.
Seriously think Nortel have an issue....
Hi guys,
We recently installed 2 new Callpilot Rls 5 servers (600r). 1 we migrated from Meridan Mail 13 and 1 we just added the mailboxes in as new. We have the same issue on both.
The callpilots took the 3 digit mailboxes ok. But now when you try to add a new mailbox it says the mailbox...
Sounds like you need HFA in the class of service for the phones to allow Handsfree. If you have HFD then you can make calls and hear then on the speaker but the mic wont work unless you have HFA.
RCO on the extension.. Ringing Cycle Option ie how many rings before doing the hunt or fdn treatment.
There are 3 rco's defined on the system and these are altered in ld 15.
Hi guys,
I have a problem with a BCM50 Rls 3 where the raw data from the PRI on BCM monitor shows the CLID of the incoming call to be correct however on LINE monitor on BCM monitor the CLID is incorrect. The bcm is adding a 0 to the front of the number.
ie if the number calling was 02890xxxxxx...
I have a MIRAN providing a RAN whenever the console is busy. However the RAN will continuously play until the console becomes free again, but if you ring the acod of the RAN route it plays once.
How do you get it to play once when overflowed from the console?
Cheers
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.