Recent content by cormon

HI Guys, I have the following requirement to achieve and just need to ensure that it is possible. Please see attached the relevant diagram. http://dl.dropbox.com/u/4426466/forum%20post.jpg The Firewall in the Middle (Data Center) has only one purpose to terminate the VPNs and hair pin them ...

duct tape it is then guys !!!!!. Cheers for all the input guys. It certainly is a funny design choice but is way more organised and logical that the current ssetup we have which is in a word "brutal" Thanks, Kevin..

Hi Guys, We are currently trying to re organise our switching topoloogy and i have a question about stackwise cabling. We use 3750 48 ports and 24 ports depending on how many ports we need. I have included a link to what the phyiscal network will look like...

Spot on Unclerio, thanks for that , plenty of bedtime reading.

Hi Guys, Looking for a bit of advise in relation to deploying a ssl based soluation on a 5510. I have read may of the config guide on the cisco website but am having a bit if difficulty finding information on the following issue. How do I ensure that the remote computer does not store any...

check out this config on ciscoblog.com that details a NBAR and Qos config that might be what you are after. http://www.ciscoblog.com/archives/2006/1/throttling_band.html Kevin

hi Guys , I am in the process of trying to find out if Policy base routing is possible on the Nokia IPSO platform. The below links seem to indicate that it may be availabe from IPSO version 4.2 onwards but i would like a definate answer http://lists.virus.org/fw1-0801/msg00021.html...

Hello Lads, I have a quick question in relation to outside access-list applied to the the external interface. I have an asa 5510 that is connecting some LAN users out to the internet . Very simple set-up just a global nat statement and simple access-list to allow the users out. Here is my...

Hi Trey , yes we are using Ip Phones . Thanks ..

Hi Lads, We are currently looking at the security of our 5500 switches and i have noticed a feature called system-guard . I am interested in finding out what this does and how best to apply it . There dosen't seem to be alot of info in relation to this on the 3com website . Does anyone have...

Good man Trey , cheers for that . On a side note we have ip phones plugged into the Ports where we want to use the port security commands. Theses ports are trunks because the ip phones are switches in essence with the P.C plugged into the ports . For some reason the port security will only learn...

Hi Lads , I am currently working on port security on one of out 5500G switches. I was wondering is there any command or macro that will allow me to modify many ports at the one time , similar to the Cisco interface range commands ?? Thanks in advance Kevin........

cheers lerdalt but again should the LEDS not be in a green state , the por being in blocked state should still have a link light , Kevin.

Cheers Burt , the fact that the LEDS on the corresponding ports are off on the 4506 ,would this not indicate a cable or interface issue. As far as I know these should still be on regardless of spanning tree putting them into a blocked state. Thanks....

a client of ours had the following topology 4006 ------ 4506 ----- 3500. ------ They were moving the the 4506 up a few slots in a comms rack. Since then they are having alot of network issues. There is only one LED on the 4506 module which is a wsx4306-GB 6. This is one of the...