Recent content by copterride

Hi, we have phones on vlan 70 and cm on vlan 130, g450 on vlan 130. will there be any issues because of different vlans? thanks,

Hi, what is needed on site for grounding G450 and CM servers(HPDL360G7). Thanks.

How do PC's connected to IP phones aquire IP address, Do they get IP address assigned from the DHCP server data pool? I know Phones are assigned IP address from DHCP voice pool !! Thank You...

Hi, Customer have given us the following IP address ranges, Telephony Servers- 10.60.130.18-10.60.130.254 VLAN-154 Network Management- 10.60.34.18-10.60.53.254 VLAN-38 IP Phones- 10.60.82.18 - 10.60.90.254 VLAN- 80 We have 1 duplex CM, 9 G450 gateways,650 IP phones, DHCP/DNS/HTTP...

We have just 2 PRI coming in from telco with 7 G450's. We have separate demarc and computer room. All Avaya servers will be in computer room.

Thanks Randy! What should be location of Avaya Rack in computer room? Does it make sense to place it near PRI OR Avaya rack can be placed anywhere in the computer room?

Hi, I have been tasked to create communications room Layout. I think Avaya rack with duplicated CM and G450(7) gateways should be near PRI connection and have Cisco Core Switch rack beside Avaya Rack. is this correct? and we dont have to worry about Demarc room correct? Thanks

phoneguy55, Does both PE ports for each server have same IP address? Which Ethernet ports you used as PE ports on DL360 HP server? CAn i Have HA with CM Server1 PE port connected to LAN switch1 and CM Server2 PE port connected to LAN switch 2? As per my understanding system domain (Dom-0) is...

Thanks again! Do yo know how many LAN ports i would need for 1. CMS and 2. SAL R610 server 3. AIM FPM and config servers?

I Have one SAL R610 server and two integrated management servers with Duplicated CM 6. can we configure SAL after setting up core CM? How many IP addresses and lan switch ports are required for SAL gateway and AIM servers? I assume one IP and one port for each server. Thanks.

Thanks phoneguy55 ! is that 2 ports for PE and duplication? OR 2 ports for PE to go into separate switches for HA?

Thanks Mitch! I also has CMS, SAL gateway server and integrated management FPM and Config severs. I assume one lan port per server. Pls correct if wrong. Also Can i setup HTTP on my DHCP server?

I have Duplex CM 6 on HP servers with 6 G450 gateways. How many and what kind ports are connected to core cisco LAN switch? My understanding is 2 eth0 ports for each CM server and 1 port for each g450. Am i correct? Also the two PRI's are connected to e1/t1 port of first 2 G450's in the rack...

ok Thanks. So the other IP addresing is correct, right?

Thanks Telm59 ! Here is what i think i should assign, pls correct me if i am wrong!! CM Server 1(HP DL360G7): Virtual active IP address(PE)- x.x.x.11 CM IP address- x.x.x.12 Cdom IP address- Sdom IP address- Sal gtwy IP address- CM Server 2(HP DL360 G7): Virtual active IP address(PE)-...