Recent content by Colmgo

You could either get a USB floppy drive, or create a bootable USB key with your Fdisk on there, or if you have the items to allow you to do this you could remove the drive from the laptop and plug it into an other PC.

Hi Everyone, I'm trying to get the not reason codes to appear in the NR Reason column in the realtime display, I put the set on not ready, ActCode button flashes, I enter code, press the button again, and that should be it however on the RTD its not visible.... Any ideas on this, thanks in...

I went to Lexmark looking for Vista driver, none there, but the 2003 driver worked a treat.

Got the fix go to syposium box and use the unpend command from the command line.

Hi All.. Not voice ports, but mail ports are stuck in deaquire pending state, SCC 4.2 tried everything to clear this. Any ideas..?

Hi Everyone, I will be taking down my PABX for a weekend, the telco company can only re-route my DDI range to one other number (option 11c) at an other site. However with in that range are a few fax numbers, can the option 11 with mail 13 detect between voice and fax and reroute accordingly? Thanks

Hi I'm trying to find out what the ext number for "prompt maintenace" is however I cant find anything in the DN table, any other ways to find it? Thanks C

Hi All, ISDN 30 is to be installed a branch office, whats the best way to confirm if PABX (opt 11) is ready? Commands etc, As far as I know its already ISDN 16. Thanks

I forgot to mention in my first message, this phone is connecting to a different PABX than it normally does.

Hi Everyone, I have a i2004 in remote office that always downloads FW after a restart. Is there setting that mybe causing this. Colm

Hi all, whats the safest procedure for shutting down mail, it still thinks its running a backup even without a tape. Mmail V13. Reboot will probably cure it..

Hi Everyone, just wondering is it possible to have two terminals attached to meridian Mail, (opt 61c) (Mmail 13). One for monitor and one connected to remote admin box... Thanks C

Hi There, can you please help with this, one M3820 (non acd) with headset (no amp) recieves a call, line key is pressed, but the caller cannot be heard. However if a call is placed from the phone everything works as normal. Thanks in advance C

Hi Everyone, anyone got any useful links to info on the benifits of Nortel/IP over Cisco/IP i'm specifically asking about voice of course. Many Thanks in advance.....

Hi All, i2050 will ring perfectly onsite but once it connected from a broadband connection via VPN. It no longer rings. All functionality is fine, any ideas? Firewall settings perhaps? Thanks so much in advance.... C