Recent content by coldblaze

Thanks everyone.

Thanks. So there is no way to do this non destructively, or without outage. What is the reason the entire PN has to be taken down?

Thanks. What I was assuming is that there must be a general procedure to campon-busy out trunks to the G650, interchange your IPSI's and TN2602 boards to the duplicate cabinet and then power down and exchange. That is the general kind of instruction I was looking for. I am also wondering if...

I need to replace a G650 cabinet and have been looking for a single document on a standard procedure to replace a G650 but have not found anything. Is there a generic process to follow when replacing a G650? Or do you simply follow the procedures outlined for replacing the individual circuit...

It is a standalone cores server. I have a SIP trunk that I am build but thats it.

When I try to run H323CallTrace I get the following: $ H323CallTrace on VTRK is not running Not sure what I need to do to enable VTRK. I am running a cores CS1000.

I am running a CoRes CS1K 7.5. I am trying to register an 1140e SIP endpoint to the server, but everytime I try, the TLAN/Node returns a 500 not implemented message back. I thought I had built everything necessary to support this, including a: Node, SIPgw, D-Channel, Zone, Customer, SIP...