Recent content by cobac

Thanks for the info. Just replaced the unit and so far seems better (well except for some static). I guess I will know better in a few days if it goes crazy again. I like the panasonic idea, might try that next...

I have a brand new T7406 with base station, just a single phone. The unit will work fine for a day or two and then it will switch to "Scanning" and it seems, forget its security code. When I go onsite, it seems the SS code changed itself twice. Once, it was reset to the original password of...

thank you

Question applys to BCM50, but I figured the question would also apply to Norstar. Is there a function to divert an incoming call directly into voicemail without answering? Example: Customer phone is ringing, they see a Caller they don't want to speak to, they would like to press a single...

I put new i2004 and a new i2002 sets in and it still has the same problem. I'm sure if you just plan on using the digital instead of the IP phones the system is fine. I put in another VOIP system and there are no problems, so it must be the system or phones.

Thanks for the info guys. Cardman - Yes, this is exactly the setup. Users have 2-3 sep lines and when line 1 is full, it rolls over to line 2, etc. (Just like previous Nortel M1 setup). Problem is connecting calls on these different lines. On an M1 you could just select the held line and...

Thanks for the speedy reply. With a meet-me I could transfer those on the line into the bridge. However, how would I accomplish this with ad-hoc? I have Caller#1 on line 1200 and caller #2 on line 1201. I select "Conf" and then if I click the held line and select join... it beeps and says...

CCM 4.1 If all calls are made under the one line/appearance I can select each call and select "Join". On the 7970 I have buttons assigned to each line, but I can't seem to join them together. (you can't select calls on other lines) How can you join calls on seperate lines/buttons... is this...

Well it is actually Call Manager "Express" and Unity "Express" is a module that plugs in that will give you just voicemail. If you wanted the full Call Manager version and/or unified messaging you would have to go with the server based models. I heard the "express" version compares to "Key"...

Have you looked into going with CM Express and Unity Express? Everything would be housed on a router without the need for extra servers.

Are there any special configuration options for a H.323 gateway to get multicast MOH functional? MOH works fine, but when I configure the MOH server for multicast and assign it to the appropriate MRG and MRL I get silence when the user is put on hold. I read somewhere that a loopback...

Same configuration you had posted previously...for MGCP The IOS version is 12.3 IP/H323 Plus Basic - believe it was 15B

Upgrade the IOS on your router to 12.3 version... FIXED my problem! I sure hope it fixes yours! I guess CCM 4.1 doesn't like the 12.2 version of IOS...

Question: Are you getting dialtone from the outside lines when you go to place a call? I have limited the 4 ports down to just using the 1st port now. (Even though I have 4 lines). I was starting to notice on outbound calls it was picking up port 1 and when that didn't go through, the...

Here is what is happening with my setup. 2620 with NM-2v and 2x VIC-2FXO-M1. 2950 Switch and CCM 4.1 Place call from the outside, line rings to the "Attendant" extension that was configured in the gateway options for each FXO port. Answer the call, silence on both ends. Approx 20...