Recent content by clumsymonkey

Having a bizarre issue that's beyond my knowledge. I configured the ASA 5505 for an IPSEC tunnel. Regardless of what remote site a user tunnels into, the tunnel comes up, both PHASE 1 and PHASE 2. From some sites, the user can successfully ping the office network resources behind the ASA, but...

Already tried that. Yes that does changes the cost of the route, but it doesn't change the administrative distance which the route table uses before cost. To change the administrative distance, I need to change the preference. Nortel has the following default preferences...

Hi, Would like to create a floating static default route on the ERS 5520, but there doesn't seem to be an option of changing the preference. The switch receives a OSPF default route, but would like to create a floating static route in case the link (where the OSPF default arrives from) goes...

Is there a way to configure when and how long a user can login for??? I know how to set priviledge levels for a user, but is there any way of controling what days they can login on, on the 2509?????

Hi, It looks like it is an authentication mismatch. I changed to chap authentication and ran the debug and below is snippet of what I got. However, my credentials are not wrong - ie they work when I use it on my dlink router - I can connect on my dlink router. What do you think can be the...

Hi, I'm trying to setup my pix 501 as a dsl client, but I can't get an ip from my isp. I know it should work because it work for my d-link router. I set my pix for dsl below: ip address outside pppoe setroute ip address inside 192.168.0.1 255.255.255.0 vpdn group whatever request dialout pppoe...

Yeah, I saw that already. That cannot work as the boot helper image is corrupt. It looks like I need a flash card!

I have a 'deleted' IOS that will not boot-up my RSM on my catalyst 5500. I don't have a flash card to boot from. I have a TFTP and it's possible to do a network boot, but I don't know how from rommon. There is no xmodem utility. Is there any way to recover the IOS or do a network boot?????? I'm...

I'm trying to get a client on each respective network to ping the others gateway, but it's not happening. What am I missing??? Here's how my 2514 is setup: interface Ethernet0 ip address 172.21.101.1 255.255.255.0 no ip directed-broadcast ! interface Ethernet1 ip address 172.22.102.1...

yeah, i need a x/o cable!! that did the trick, thnx.

I can't get a link when I plug a PC NIC into the AUI port on the 2514 via the 10BaseT transceiver. I can get a link when I plug a switch into the transceiver. Why can't I get a link when I plug the PC's NIC into the AUI transceiver??? Am I missing something???