Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by clintock

  1. clintock

    Extreme 350 head cleaning measures..

    I have a junk 350 that I'm spending way too much time fooling with, that I finally managed to get through all it's warm up paces, only to find I'm unable to clear the head. This one has many blank stripes on the clean test page. I've used a heart breaking amount of ink in self-cleaning modes...
  2. clintock

    Phaser 350 printing problem

    I am guessing, but perhaps the cap/wipe/purge rubber gasket has come off from the steel part of the assembly. Take out the maintenance tray and look inside the printer where it was. A flashlight of similiar light may help- See the pinkish rubber strip with the drip points on it so the purged...
  3. clintock

    Will 360 motherboard work in 350?

    I was wary of trying the wrong board in the printer, so I emailed the seller and he also had a 350 pulled board. He said that he also encountered the same error code in the past, and swapping the board was the only way he managed to fix the problem. Sad, as I feel all that is wrong with the...
  4. clintock

    Will 360 motherboard work in 350?

    I'm thinking it's easier to get another working motherboard than to reset whatever is causing the 4,006 error I have in one of my 350, and there is a 360 pulled board on ebay- Will it work?(360 board in 350 body)
  5. clintock

    Tektronix Phaser 350 Error 04,006.45:715

    If anyone is still watching me flail with my 350--blog of the 350 Having discoverd the bypas mode (duh) I was able to get to the menus and reset the mother board nvram. Nothing. still the 4,006. I called a local qualified tech and he thought maybe the Head Nvram needed to be reset. Ugh. So...
  6. clintock

    Tektronix Phaser 350 Error 04,006.45:715

    No luck with swapping dallas nvrams- the error follows the mother board. Swapped the simms too. Same deal, fault 4006 during warm up when it gets to around 15 percent. grrr
  7. clintock

    Tektronix Phaser 350 Error 04,006.45:715

    Troubleshooting using two 350- I discovered the error follows the board not the printer. Motherboard that is.. Now to switch nvram and see what happens..
  8. clintock

    Tektronix Phaser 350 Error 04,006.45:715

    Hi, I have the same problem with one of my 350- and looked up the code, found the same blurb as above. Fat lot of good that is! Ok- Which hardware? How do I re-normalize? I dug around for how to normalize in the 360 troubleshooting guide that I found online, and all it says is head normalization...
See more

Part and Inventory Search

Back
Top