Recent content by ciscoric

Thanks for the response. That is pretty much what I figured.

We are upgrading our Exchange server from Exchange 2000 to exchange 2007. The problem I have is the Proliant ML 350 G3 server is only 32 bit. Exchange 2007 minimum requirements are 64 bit. I am hoping to upgrade the processor on the server to a 64 bit processor. Does anyone know if this is...

Davetoo Over 12 hours later and all is well. Performance Monitor shows an average of 1-2 emails being sent, and the Firewall is showing no outbound SMTP traffic except legitimate emails. Thank You for the help. I should have checked here a couple of weeks ago.

Thank you for the help. I have unchecked Allow Delivery reports and also unchecked Allow non delivery reports in the advanced tab under Internet message formats. I am going to clear the queues and I will let you know what I find. Thanks again.

I know for weeks sounds bad but every time I think I have it it comes back. And I was not totally sure I was not relaying until today. When I look at the Queues they are all Postmaster@domain.com non-deliverable. I do not think I am looking at the outbound queue. I am obviously missing something.

I have an exchange 2000 server that is sending constant emails outbound. Looking at the performance monitor I see there are about 40-200 emails going out at any given time. This is for a small network for about 20 users and there is no way they are sending that many emails. I have checked to...

We have a winner! Thank you feipezi, this code works perfectly. It is exactly what I have been searching for for years. I will put this into action imediatly. Ric Johnson

Thank you for the reply SkipVought, The totals for the day would be manually entered each day by the supervisor at the end of the shift.

We have a production summary report that needs to keep a daily count of what was produced on each job. The excel sheet has a column with the number of pieces produced today, and a column with the total number of pieces produced. We want to be able to enter the number produced today in the number...

Thank you for pointing me in the right direction xlhelp.

xlhelp, Thank you for the quick reply. Actually the daily count data would always be in the B2 cell and the total would always be in the C2 cell. Example: Monday's entry would be: A B C 1 Job# Total Daily Total Count 2 12163 1,000 1,000...

We have a production summary report that needs to keep a daily count of what was produced on each job. The excel sheet has a column with the number of pieces produced today, and a column with the total number of pieces produced. We want to be able to enter the number produced today in the number...

I am trying to get Terminal Service set up for web access. I can reach the tsweb portion from inside of the network. I need to allow web access to this server also. I have a cisco 1760 router and with T-1 access. I also have a watchguard 700 firewall. I assume I am not even reaching the...

The error is cannot find network location. I am logged on to the Domain. Also, all pre-exsiting mappings still work and all computer that previously were able to log in to the domain still can, but I cannot add any new ones.

I ran ipconfig /all, this shows all of the correct information for this server. The nbtstat -rr did refresh the table but gave me no results. This has been happening for a few days now. Before that it was working fine. Still no luck.