Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ciccotelli

  1. ciccotelli

    Software

    Try shorting the battery on the motherboard for about 10 seconds to reset the system to a clean config prior to installing the older version of software.
  2. ciccotelli

    Startalk Compatibility

    Telecomplus I would try and short the battery on the MICS motherboard prior to installing the older version of software so you start the system with a clean slate.
  3. ciccotelli

    Startalk Compatibility

    Thanks Telemarv. I did get a 2.01 and it works great. An interesting note. I had a problem initializing the system because it had a VMI interfaced Applied Voice Lingo on the system previously. The feature 903 to reset the new Startalk is the same as the VMI configuration code. I had to reset the...
  4. ciccotelli

    Startalk Compatibility

    Thanks telemarv. I have ordered the 1.9 Startalk software.
  5. ciccotelli

    Startalk Compatibility

    I'm trying to install a Startalk Flash 4 Ver 1.36 on a newer CICS version 30CGE02 NAT. The system recognize the ports as STK1, but it doesn't respond to F983, F985 or calling it. Are the systems compatible or could I have a defective Startalk?
  6. ciccotelli

    Can't connect WinSPM using an internal 56k modem

    I call the site and have the customer transfer me into *10. Should I have them blind transfer without me on the line? I would like to set up a DID for future use. Would I renumber the port to a DID to accomlish this?
  7. ciccotelli

    Can't connect WinSPM using an internal 56k modem

    I hear the modem at the distant end, I hear my modem tone but the 2 never connect and eventually SPM says carrier not detected.
  8. ciccotelli

    Can't connect WinSPM using an internal 56k modem

    I have no problem connecting with an external US Robotics modem, however when I try and use any of 3 internal 56K modems the connections always fails. Is there a setting on high speed modems or within SPM that allows for connections at 1200/2400 baud? Thanks.
  9. ciccotelli

    Connecting with WinSPM

    I am having trouble connecting manually with high speed internal modems at 1200/2400 baud. Using external US Robotics works fine, but none of my internal modems work. Is there a setting on internal modems to allow them to connect properly?
  10. ciccotelli

    How can I transfer to an extension after leaving message

    I've installed a NAM at a customer who had a Startalk. They used to dial * in while listening to a greeting or leaving a message to transfer to another extension. Now * exits the system. What am I missing? Appreciate any help. I can't see it in the books.

Part and Inventory Search

Back
Top